Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
9825064 | Energy | 2005 | 12 Pages |
Abstract
The performance of high temperature air combustion (HiTAC) depends on the heat regenerator efficiency and on the way fuel is mixed with furnace gases. In this work, combustion of a single fuel jet of gasol (>95% of propane) was investigated experimentally. Experiments were carried out in steady-state conditions using a single jet flame furnace. The jet of fuel was co-axially injected into high temperature exhaust gases generated by means of a gas burner also fired with gasol. Thus, instead of highly preheated and oxygen depleted air, which was normally used by other researches for such studies, this work has used high temperature and low oxygen content exhaust gases as the oxidiser. A water-cooled fuel nozzle was used to control fuel inlet temperature. Influence of the oxygen content in the oxidiser, at temperatures of 860-890 °C, on the flame visibility and the reactants composition was investigated. The combustion of gasol in hot flue gases appeared to be very stable and complete even at very low oxygen concentration. The oxygen concentration in the oxidiser was found to have a substantial effect on flame size, luminosity, colour, visibility and lift-off distance. Reduced oxygen concentration increases the flame size and lift-off distance, and decreases luminosity and visibility. The HiTAC flame first became bluish and then non-visible at sufficiently low concentration of oxygen in the oxidiser. In this work, results are presented for the constant ratio between fuel jet velocity and velocity of co-flowing flue gases. This ratio was equal to 26.
Related Topics
Physical Sciences and Engineering
Energy
Energy (General)
Authors
Simon Lille, Wlodzimierz Blasiak, Marcin Jewartowski,