A new thermodynamic model for shaftwork targeting on total sites

The purpose of the paper is to introduce a targeting model based on a new thermodynamic insight on cogeneration in general and Rankine cycle in particular. The insight permits to express the ideal shaftwork of a cogeneration unit through the outlet heat load and the difference in Carnot factors between the heat source and heat sink for the given inlet temperature of the heat source. The deviation from the ideal shaftwork to the real one is assessed by using the traditionally turbine isentropic efficiency. Finally the new model allows targeting fuel consumption, cooling requirement and shaftwork production with high accuracy and visualizing them directly as special segments on the T-H diagram. A modified Site Utility Grand Composite Curve (SUGCC) diagram is proposed and compared to the original SUGCC. The shape of the right hand side of the diagram above site pinch is the same, however, below site pinch it is shifted to the left by an amount equal to shaftwork production below site pinch. Above site pinch VHP consumption is also corrected to account for shaftwork production above site pinch that is represented by segments rather than areas on the left hand side of the T-H diagram.