| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 1275731 | International Journal of Hydrogen Energy | 2013 | 11 Pages |
We report on the photoelectrochemical performances of a nanocomposite photoactive material made of copper tungstate (CuWO4) and multi-wall carbon nanotubes (MWCNT). The purpose of this work was to create a light absorber/charge collector composite material with tunable electronic transport properties to minimize the bulk resistance of CuWO4 material class. Nanocomposite thin films (typically 2.0 ± 0.1 μm) were fabricated by means of spray pyrolysis using solutions containing copper acetate, ammonium metatungstate and MWCNT. Spray-deposited polycrystalline CuWO4 films were found to be porous, though crack-free, and made of CuWO4 nanoparticles with dimensions in the 10–50 nm range. Tauc plots derived from UV–visible and photocurrent spectroscopy techniques led to a consistent band gap value of 2.20 (±0.05) eV. Electrochemical impedance spectroscopy performed in pH10 buffer solution under Air Mass 1.5 global (AM1.5G) at 0.8 V vs. saturated calomel electrode (1.63V vs. reversible hydrogen electrode) pointed out a bulk resistance reduction by 30% on nanocomposites photoanodes when compared to un-modified CuWO4 control samples. It is worth mentioning that the reduction in bulk resistance was achieved with an extremely low MWCNT:CuWO4 weight ratio (1:10,000), in which MWCNT absorbed less than 2% of incoming light. Subsequent linear scan voltammetry (LSV) performed in the same conditions revealed a photocurrent density increase of 26% at 0.8 VSCE (1.63 VRHE) compared to control samples. Additional LSV and incident photon-to-current efficiency measurements demonstrated that MWCNT served as effective electron collectors distributed throughout the entire CuWO4 bulk.
Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slideHighlights► Nanocomposite materials made of CuWO4 and carbon nanotubes were synthesized. ► The addition of nanotubes successfully lowered CuWO4 bulk resistivity. ► Nanocomposites shown photocurrent density 30% higher than control samples. ► IPCE analyses shown that nanotubes acted as distributed current collector in CuWO4.
