Characterization and comparative analysis of the tensile properties of five tempered martensitic steels and an oxide dispersion strengthened ferritic alloy irradiated at ≈295 °C to ≈6.5 dpa

•Tensile tests were performed at 25 and 300 °C on 6 ferritic steels irradiated to 6.5 dpa at 295 °C in the Advanced Test Reactor.•The irradiated true stress/true strain curves deform by strain softening, nearly perfectly plastic or strain hardening.•The heat of 12Cr HT-9 steel has a much higher uniform elongation after irradiation than observed for earlier heats.•This new heat of HT-9 has lower interstitial free nitrogen than previous heats.

Tensile test results at 25 and 300 °C on five 9-12Cr tempered martensitic steels and one 14Cr oxide dispersion strengthened alloy, that were side-by side irradiated to 6.5 dpa at 295 °C in the Advanced Test Reactor (ATR), are reported. The engineering stress–strain curves are analyzed to provide true stress–strain constitutive σ(ε) laws for all of these alloys. In the irradiated condition, the σ(ε) fall into categories of: strain softening, nearly perfectly plastic and strain hardening. Increases in yield stress (Δσy) and reductions in uniform strain ductility (eu) are observed, where the latter can be understood in terms of the alloy's σ(ε) behavior. Increases in the average σ(ε) in the range of 0–10% strain are smaller than the corresponding Δσy, and vary more from alloy to alloy. The data are also analyzed to establish relations between Δσy and coupled changes in the ultimate stresses as well as the effects of both test temperature and the unirradiated yield stress (σyu). The latter shows that higher σyu correlates with lower Δσy. In five out of six cases the effects of irradiation are generally consistent with previous observations on these alloys. However, the particular heat of the 12Cr HT-9 tempered martensitic steel in this study has a much higher eu than observed for earlier heats. The reasons for this improved behavior are not understood and may be microstructural in origin. However, it is noted that the new heat of HT-9, which was procured under modern quality assurance standards, has lower interstitial nitrogen than previous heats. Notably lower interstitial solute contents correlate with improved ductility and homogenous deformation in broadly similar steels.