Article ID Journal Published Year Pages File Type
179550 Electrochemistry Communications 2013 5 Pages PDF
Abstract

We report an efficient solar-light-driven photocatalyst based on three-dimensional nanoporous tungsten trioxide (WO3) films. These films are obtained by anodizing W foils in fluoride-containing electrolytes at room temperature and under low applied voltages with an efficient growth rate of 2 μm h− 1. The maximum thickness of the films is ~ 3 μm that exceeds those of previously reported anodized WO3 films in fluoride-containing electrolytes. By investigating the photocatalytic properties of the films with thicknesses ranging from ~ 0.5 to ~ 3 μm, the optimum thickness of the nanoporous film is found to be ~ 1 μm, which demonstrates an impressive 120% improvement in the photocatalytic performance compared to that of a RF-sputtered nanotextured film with similar weights. We mainly ascribe this to large surface area and smaller bandgap.

► Anodized 3D nanoporous WO3 films were prepared at room temperature and under a low applied voltage. ► The thicknesses of the nanoporous WO3 films were up to ~ 3 μm with a growth rate of ~ 2 μm h− 1. ► Field-assisted dissolution was the dominate mechanism to the formation of this 3D nanostructure. ► The crystal phase of the nanoporous film is orthorhombic with a relatively small bandgap of 2.73 eV. ► The photocatalytic property of the nanoporous film shows 120% improvement compared to a sputtered film.

Related Topics
Physical Sciences and Engineering Chemical Engineering Chemical Engineering (General)
Authors
, , , , , , , ,