Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
2487886 | Journal of Pharmaceutical Sciences | 2006 | 10 Pages |
Abstract
The long-term goal is to develop a spray formulation for transdermal testosterone delivery, and to optimize the drug's skin permeability. Testosterone transport from a series of ethanol/propylene glycol (PG)/water formulations was assessed in vitro across hairless rat skin, and the optimal composition determined. The formulation was then modified for delivery from a mechanical spray, and from an aerosol containing a high percentage of propellant. Drug transport was greatest from a saturated solution in 1:1:1 ethanol/PG/water (1.7 ± 0.2 µg/cm2 · h); five spray formulations were then tested, but only 1:1 ethanol/PG achieved a comparable flux. Increasing the % ethanol in the mixture increased evaporation rate but did not alter testosterone delivery. Formulation as an aerosol produced primarily unstable vehicles (phase separation, crystallization). Only 3:1 ethanol/PG remained stable, but no significant improvement in drug transport was observed (testosterone precipitated rapidly at the skin surface). The 1:1:1 ethanol/PG/water saturated solution suggested that some penetration enhancement was possible. Eliminating water to improve sprayability identified 1:1 ethanol/PG as a vehicle, which might allow transient supersaturation (and improved delivery). However, this effect was not improved by using a pressurized aerosol due to instability. Finally, testosterone fluxes were 5 to 10-fold lower than those required for useful transdermal therapy.
Related Topics
Health Sciences
Pharmacology, Toxicology and Pharmaceutical Science
Drug Discovery
Authors
Marie-Laure Leichtnam, Hervé Rolland, Patrick Wüthrich, Richard H. Guy,