Drug/lactose co-micronization by jet milling to improve aerosolization properties of a powder for inhalation

The aim of this work was to formulate a powder for inhalation with fusafungine, a drug substance initially highly cohesive. The classical approach based on micronization by jet milling to prepare respirable drug particles and then blending with a carrier was first applied. A fractional factorial experimental design was implemented to screen six formulation parameters. The effect of drug/lactose co-micronization on aerosolization was then evaluated. In vitro deposition studies were performed with the twin stage glass impinger and the inhaler Spinhaler®. Micronization did not induce DSC-detectable amorphization and gave a highly cohesive, poor flowable powder with a theoretical aerodynamic diameter of 5 μm. The powder was then blended with coarse lactose and optionally fine lactose. Unfortunately, the respirable fraction could not be optimized and remained below 10%. On the other hand, a co-micronized powder drug/fine lactose 50:50 gave a respirable fraction of 16%. Following blending with a carrier, the respirable fraction and the emitted dose fraction reached 23% and 69%, respectively. The use of a fine lactose grade for co-micronization was essential. In conclusion, this study demonstrated that co-micronization with a fine lactose is an efficient and simple strategy to formulate a powder for inhalation with enhanced aerosolization properties, especially for highly cohesive drug substance.