Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
398550 | International Journal of Electrical Power & Energy Systems | 2015 | 14 Pages |
•A Decoupled control of grid connected inverter using dynamic grid impedance for a micro-grid application is presented.•Varying network configuration of micro-grid due to renewable sources makes the line impedance to vary during the operation.•The mismatch between the actual and the decoupling impedances cause transients during step change in power references.•In this paper the impedance for decoupling is obtained and updated in the control loop dynamically by measuring it online.•A perfect decoupling with independency in inverter’s active and reactive power control is achieved without any transients.
This paper presents a decoupled control of grid connected inverter using dynamic online grid impedance measurements for a micro grid application. The proposed controller is implemented in synchronous reference frame (SRF) and controlled using linear PI controllers. The mutual coupling introduced between the d and q control loops due to the transformation into SRF is accurately decoupled using the dynamically measured grid impedance using a feed-forward control. The decoupling allows independent control of active and reactive powers against step changes in the active/reactive power references. The online measurement of the actual impedance and its use further for decoupling is proposed in this paper for making the decoupling accurate inspite of the network configuration being altered like in micro grids. Here the grid resistance and inductance are measured during the operation using a non-characteristic frequency current continuously injected into the grid, and subsequently calculating the impedance using discrete Fourier transforms. The continuous injection of non-characteristic current at 75 Hz avoids the injection of sub-harmonics into the grid during measurements. The control loop is updated periodically with the estimated grid impedance, thus enabling the independent control of active and reactive powers delivered by the inverter. The proposed decoupled controller with grid impedance measurement is tested through simulation studies and hardware experiments. The experiments are conducted with the proposed controller on a scaled down laboratory model of micro-grid with a 1 kVA solar inverter, and the performances are presented for step changes in the power references and the results are presented.