| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 506989 | Computers & Geosciences | 2016 | 10 Pages |
•Development of a low-cost seismic recorder with amplifier and anti-aliasing filter.•Geophonino is an open source and open hardware system.•After configuration, data acquisition does not require any laptop connection.•Comparisons with commercial systems confirm the right performance of Geophonino.
The commercial data acquisition systems used for seismic exploration are usually expensive equipment. In this work, a low cost data acquisition system (Geophonino) has been developed for recording seismic signals from a vertical geophone. The signal goes first through an instrumentation amplifier, INA155, which is suitable for low amplitude signals like the seismic noise, and an anti-aliasing filter based on the MAX7404 switched-capacitor filter. After that, the amplified and filtered signal is digitized and processed by Arduino Due and registered in an SD memory card. Geophonino is configured for continuous registering, where the sampling frequency, the amplitude gain and the registering time are user-defined. The complete prototype is an open source and open hardware system. It has been tested by comparing the registered signals with the ones obtained through different commercial data recording systems and different kind of geophones. The obtained results show good correlation between the tested measurements, presenting Geophonino as a low-cost alternative system for seismic data recording.
Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide
