Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
507223 | Computers & Geosciences | 2014 | 10 Pages |
•The volume of landslide could be estimated with single remote sensing image without any ground control points.•Neither professional training nor photogrammetry software is required for getting volume change with less than 25% error.•Any archived image data can be utilized to compute the amount of temporal terrain change.•This method provides an easy way to gather terrain change immediately after the event.•Entropy of the image and also existence of shadow are the key factor to affect the accuracy.
Information regarding the scale of a hazard is crucial for the evaluation of its associated impact. Quantitative analysis of landslide volume immediately following the event can offer better understanding and control of contributory factors and their relative importance. Such information cannot be gathered for each landslide event, owing to limitations in obtaining useable raw data and the necessary procedures of each applied technology. Empirical rules are often used to predict volume change, but the resulting accuracy is very low. Traditional methods use photogrammetry or light detection and ranging (LiDAR) to produce a post-event digital terrain model (DTM). These methods are both costly and time-intensive. This study presents a technique to estimate terrain change volumes quickly and easily, not only reducing waiting time but also offering results with less than 25% error. A genetic algorithm (GA) programmed MATLAB is used to intelligently predict the elevation change for each pixel of an image. This deviation from the pre-event DTM becomes a candidate for the post-event DTM. Thus, each changed DTM is converted into a shadow relief image and compared with a single post-event remotely sensed image for similarity ranking. The candidates ranked in the top two thirds are retained as parent chromosomes to produce offspring in the next generation according to the rules of GAs. When the highest similarity index reaches 0.75, the DTM corresponding to that hillshade image is taken as the calculated post-event DTM. As an example, a pit with known volume is removed from a flat, inclined plane to demonstrate the theoretical capability of the code. The method is able to rapidly estimate the volume of terrain change within an error of 25%, without the delays involved in obtaining stereo image pairs, or the need for ground control points (GCPs) or professional photogrammetry software.