| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 560487 | Mechanical Systems and Signal Processing | 2014 | 16 Pages |
•The method simplifies output-only modal analysis using continuous-scan laser Doppler vibrometry.•The method uses the positive harmonic correlation function of the linear time periodic system to lift the measurements.•The method is validated on a simulated free–free beam that is randomly excited.•The method is compared with a previous algorithm based on the harmonic power spectrum.•The method is used to identify modal parameters of a wind turbine with a remote sensing vibrometer.
Continuous-scan laser Doppler vibrometry (CSLDV) can greatly accelerate modal testing by continuously sweeping the measuring laser over a structure, effectively capturing its response at tens or even hundreds of points along the laser path. Several techniques have been devised to process CSLDV measurements from structures under controlled input. The authors recently extended CSLDV to the case where the input forces are unmeasured random white noise, using the harmonic power spectrum of a time periodic system. The harmonic power spectrum is analogous to the power spectrum used in the identification of time invariant systems, but with many additional harmonics for each mode, requiring an additional effort in modal parameter estimation. This paper presents a variant on the harmonic power spectrum, proposing a simplified algorithm based on the lifting approach. Lifting causes all sideband peaks in the harmonic power spectrum to collapse into a single peak in the range from zero to half of the scan frequency, so the spectra are far easier to interpret. The proposed algorithm is first evaluated on a simulated beam, and found to give results that are comparable with those obtained by the harmonic power spectrum method, yet the data reduction with the lifting approach is much simpler. This algorithm is then employed to identify the first several modes of a parked wind turbine under wind excitation, using a new long range remote sensing vibrometer. The speckle noise is found to be remarkably small even at a standoff distance of 77 m and a surface scan velocity of 500 m/s without any surface treatment.
