Article ID Journal Published Year Pages File Type
620653 Chemical Engineering Research and Design 2013 8 Pages PDF
Abstract

•The DMF adsorption equilibrium may be described by the Henry equation.•The adsorption temperature has little effect on the adsorption process.•The surface diffusion coefficient was approximately 3.50 × 10−10 to 1.06 × 10−9 m2 s−1.•The desorption rates were greater than 99%.•The adsorption–distillation process can reduce the energy consumption by 79%.

To reduce the high energy consumption during the traditional ordinary distillation process for recycling N,N-dimethyl formamide (DMF), this paper utilized the NKA-II macroporous adsorptive resin in combination with a distillation process to recycle DMF in wastewater. First, the adsorption equilibrium data were measured in the intermittent agitation tank, which showed that the DMF adsorption equilibrium on the NKA-II resin complies with the Henry equation. The dynamic experimental studies indicated that the adsorption temperature has little effect on the adsorption process; the flow rate and the bed height affect the breakthrough time but have little effect on the mass transfer zone. With the combination of the fixed-bed adsorption model and the breakthrough curve, the surface diffusion coefficient of the DMF on the resin in the fixed bed was approximately 3.50 × 10−10 to 1.06 × 10−9 m2 s−1. The simulated values were in good agreement with the breakthrough curves determined by experiments. Furthermore, ethanol was selected as a better desorption agent. The appropriate desorption conditions were determined to be a flow rate of 8.00 × 10−5 m s−1 to 1.58 × 10−4 m s−1 and a temperature of 308–318 K. Under these conditions, the desorption rates were all greater than 99%. Finally, wastewater that contained 5% DMF was used as an example to analyze the energy consumption. The results indicated that the adsorption–distillation process can reduce the energy consumption by 79%. The adsorption–distillation process has a good applicable value for the recovery of DMF in wastewater, especially for wastewater with a low concentration of DMF.

Related Topics
Physical Sciences and Engineering Chemical Engineering Filtration and Separation
Authors
, , , ,