Influence of ring-type internals on the solids residence time distribution in the fuel reactor of a dual circulating fluidized bed system for chemical looping combustion

The intensification of gas-solids contact in the fuel reactor of a chemical looping combustion system is enhanced with the installation of ring-type internals. This can be a key issue for achieving the necessary fuel conversion rates. Wedged rings, previously designed and tested, were found to increase the particle concentration in the counter current section of the fuel reactor and hence, to achieve a more homogeneous particles concentration along this zone. The present work investigates the effect of the mentioned internals on the residence time distribution of particles in the fuel reactor of a dual circulating fluidized bed system for chemical looping. The study was carried out in a cold flow model especially designed for the fluid-dynamic analysis of the system equipped with a recently developed residence time measurement device based on the detection of ferromagnetic tracer particles through inductance measurement. Ring internals proved the positive effect on the particles residence time, the residence time distribution is more symmetric and shows lower dispersion, the flow pattern is more plug-flow-like, these effects are intensified with the reduction of the aperture ratio of the rings. On the other hand, the upward particle transport in the counter-current zone of the fuel reactor also increases with the installation of the rings, increasing the bypass flow of solids through the fuel reactor's return loop (internal circulation). For high internal circulation rates the solids residence time distribution of the fuel reactor is dominated by the bypass effect. The findings may be used for focused design improvement of the investigated fluidized bed system.