Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
647654 | Applied Thermal Engineering | 2011 | 7 Pages |
This work investigates the influence of compression ratio (CR) and injection parameters such injection timing (IT) and injection pressure (IP) on the performance and emissions of a DI diesel engine using biodiesel (%5, 20%, 50%, and 100%) blended-diesel fuel. Tests were carried out using three different CRs (17, 18, and 19/1), ITs (15°, 20°, and 25° CA BTDC) and IPs (18, 20 and 22 MPa) at 20 N m engine load and 2200 rpm. The results showed that brake specific fuel consumption (BSFC), brake specific energy consumption (BSEC), and nitrogen oxides (NOx) emissions increased while brake thermal efficiency (BTE), smoke opacity (OP), carbon monoxide (CO) and hydrocarbon (HC) decreased with the increase in the amount of biodiesel in the fuel mixture. The best results for BSFC, BSEC and BTE were observed at increased the CR, IP, and original IT. For the all tested fuels, an increase in IP, IT and CR leaded to decrease in the OP, CO and HC emissions while NOx emissions increase.
► The influence of engine operating conditions on a diesel engine using biodiesel was examined. ► Tests were carried out at different compression ratios (CRs), injection timings (ITs) and injection pressures (IPs). ► NOx emissions increased while smoke opacity, CO and HC decreased with the increase biodiesel amount. ► Best results for BSFC, BSEC and BTE were observed at increased the CR, IP, and original IT.