Experimental investigation of mixed convection heat transfer for thermally developing flow in a horizontal circular cylinder

An experimental investigation is presented on mixed (free and forced) convection to study the local and average heat transfer for hydrodynamically fully developed, thermally developing and thermally fully developed laminar air flow in a horizontal circular cylinder. The experimental setup consists of aluminum cylinder as test section with 30 mm inside diameter and 900 mm heated length (L/D = 30), is subjected to a constant wall heat flux boundary condition. The investigation covers Reynolds number range from 400 to 1600, the heat flux varied from 60 W/m2 to 400 W/m2 and with cylinder inclination angle of θ = 0° (horizontal). The hydrodynamically fully developed condition is achieved by using an aluminum entrance section pipes (calming sections) having the same inside diameter as test section pipe but with variable lengths. The entrance sections included two long calming sections, one with length of 180 cm (L/D = 60), another one with length of 240 cm (L/D = 80) and two short calming sections with lengths 60 cm (L/D = 20), 120 cm (L/D = 40). The surface temperature variation along the cylinder surface, the local and average Nusselt number variation with the dimensionless axial distance Z+ were presented. For all entrance sections, it was found an increase in the Nusselt number values as the heat flux increases. It was concluded that the free convection effects tended to decrease the heat transfer results at low Re while to increase the heat transfer results for high Re. The combined convection regime could be bounded by a suitable selection of Re number ranges and the heat flux ranges. The obtained Richardson numbers (Ri) range varied approximately from 0.13 to 7.125. The average Nusselt numbers were correlated with the (Rayleigh numbers/Reynolds numbers). The proposed correlation has been compared with available literature and showed satisfactory agreement.