Machining behaviour of silicon nitride tools coated with micro-, submicro- and nanometric HFCVD diamond crystallite sizes

Very smooth CVD diamond films are used as direct coatings on Si3N4 tool substrates. By adjusting deposition parameters, namely Ar/H2 and CH4/H2 gas ratios, and substrate temperature, nano- (27 nm) and submicrometric (43 nm) crystallite sized grades were produced in a hot filament reactor. Also, a conventional 5 and 12 μm micrometric grain size types were produced for comparison. Normalized coated inserts were tested for dry turning of WC–25 wt.% Co hardmetal. All the CVD diamond grades endured the hardmetal turning showing slight cratering, having the flank wear as the main wear mode. Their turning performance was distinct, as a consequence of morphology and surface roughness characteristics. Among all the tested tools, the more even surface and the submicrometric grade presented the best behaviour regarding cutting forces, tool wear and workpiece surface finishing. For this coating, the depth-of-cut force attained the lowest value, 150 N, the best combination of wear types (KM = 30 μm, KT = 2 μm and VB = 110 μm) and workpiece surface finishing (Ra = 0.2 μm).