Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
7139943 | Sensors and Actuators B: Chemical | 2018 | 24 Pages |
Abstract
This paper described a quartz crystal microbalance (QCM) humidity sensor based on fullerene (C60)/graphene oxide (GO) nanocomposites. Humidity sensing properties such as the quality factor, frequency response property, response/recovery time, and humidity hysteresis were measured and quantitatively compared with a GO based QCM humidity sensor. The experiments provided evidences that the GO film was viscous even at low relative humidity, which had a large impact on the measurable result of a GO coated QCM humidity sensor. As a result, the proposed sensor showed better performances at quality factor and dynamic response/recovery behavior than the GO based QCM humidity sensor. Based on the admittance analysis and frequency response analysis of the sensors, it was speculated that the introduction of C60 molecules into GO reduced the aggregation of the GO sheets and formed some hydrophobic isolation layers between the GO sheets, which could inhibit the water molecules permeation and maintain the mechanical stiffness of the C60/GO film.
Related Topics
Physical Sciences and Engineering
Chemistry
Analytical Chemistry
Authors
Xing Ding, Xiangdong Chen, Xinpeng Chen, Xuan Zhao, Ning Li,