Engineering Structures - Volume 148 

A new evaluation procedure for the strut-and-tie models of the disturbed regions of reinforced concrete structures

Fulltext Access 13 Pages 2017

Wind effect on grooved and scallop domes

Fulltext Access 15 Pages 2017

Optimization of the box section of the main girder of the single-girder bridge crane by applying biologically inspired algorithms

Fulltext Access 14 Pages 2017

Equivalent Static Wind Loads: Recent developments and analysis of a suspended roof

Fulltext Access 10 Pages 2017

Large displacement analysis of dry-jointed masonry structures subjected to settlements using rigid block modelling

Fulltext Access 12 Pages 2017

Development and validation of European guidelines for seismic qualification of post-installed anchors

Fulltext Access 12 Pages 2017

Doppler radar-derived wind field of five tornado events with application to engineering simulations

Fulltext Access 13 Pages 2017

Experimental and numerical research on gear-bolt joint for free-form grid spatial structures

Fulltext Access 19 Pages 2017

Comparative evaluation of two simulation approaches of deck-abutment pounding in bridges

Fulltext Access 11 Pages 2017

Estimating number of simultaneously yielding stories in a shear building subjected to earthquake excitation

Fulltext Access 19 Pages 2017

Distribution of peak shear stress in finite element models of reinforced concrete slabs

Fulltext Access 13 Pages 2017

Self-powered piezo-floating-gate sensors for health monitoring of steel plates

Fulltext Access 18 Pages 2017

Structural dynamics of a dowelled-joist timber floor in the low-frequency range modelled using finite element simulation

Fulltext Access 19 Pages 2017

Structural assessment of masonry arch bridges by combination of non-destructive testing techniques and three-dimensional numerical modelling: Application to Vilanova bridge

Fulltext Access 18 Pages 2017

Effects of podium interference on shear force distributions in tower walls supporting tall buildings

Fulltext Access 21 Pages 2017

Cyclic tests for steel frame with unbonded steel plate brace encased in panel

Fulltext Access 19 Pages 2017

A probabilistic approach for the linear behaviour of glued laminated timber

Fulltext Access 13 Pages 2017

A parametric investigation on the seismic capacity of masonry cross vaults

Fulltext Access 18 Pages 2017

Residual ultimate strength assessment of double hull oil tanker after collision

Fulltext Access 14 Pages 2017

Variability in the predicted seismic performance of a typical seat-type California bridge due to epistemic uncertainties in its abutment backfill and shear-key models

Fulltext Access 21 Pages 2017

Analysis of passively-damped coupled shear walls using continuum-based models

Fulltext Access 16 Pages 2017

Shear force demand on headed stud for the design of composite steel plate shear wall

Fulltext Access 13 Pages 2017

Seismic retrofit of external concrete beam-column joints reinforced by plain bars using steel angles prestressed by cross ties

Fulltext Access 16 Pages 2017

A hybrid analysis method for displacement-monitored segmented circular tunnel rings

Fulltext Access 18 Pages 2017

An algorithm for dynamic vehicle-track-structure interaction analysis for high-speed trains

Fulltext Access 21 Pages 2017

Patterns of force:length ratios for the design of compression structures with inner ribs

Fulltext Access 12 Pages 2017

Influence of pounding and skew angle on seismic response of bridges

Fulltext Access 17 Pages 2017

Damage detection, localization and quantification in conductive smart concrete structures using a resistor mesh model

Fulltext Access 12 Pages 2017

Cyclic behavior of endplate connections to tubular columns with novel slip-critical blind bolts

Fulltext Access 14 Pages 2017

Dynamic and residual behavior of reinforced concrete floors following instantaneous removal of a column

Fulltext Access 10 Pages 2017

Hysteretic mechanical property of low-yield strength shear panel dampers in ultra-large plastic strain

Fulltext Access 12 Pages 2017

Finite element modeling of steel-polypropylene hybrid fiber reinforced concrete using modified concrete damaged plasticity

Fulltext Access 13 Pages 2017

Modeling and mitigation of excessive dynamic responses of wind turbines founded in warm permafrost

Fulltext Access 11 Pages 2017

Performance of an innovative self-centering buckling restrained brace for mitigating seismic responses of bridge structures with double-column piers

Fulltext Access 16 Pages 2017

Modeling cyclic inelastic in-plane flexural behavior of concrete filled sandwich steel panel walls

Fulltext Access 18 Pages 2017

Proposal of a tuned mass damper with friction damping to control excessive floor vibrations

Fulltext Access 20 Pages 2017

Effects of rockfall on an elastic-plastic member: A novel compliance contact model and dynamic response

Fulltext Access 19 Pages 2017

Comparison of thrust line analysis, limit state analysis and distinct element modeling to predict the collapse load and collapse mechanism of a rammed earth arch

Fulltext Access 12 Pages 2017

Experimental and numerical studies of hysteretic response of triple-truss-confined buckling-restrained braces

Fulltext Access 18 Pages 2017

Effect of seismic hazard definition on isolation-system displacements in nuclear power plants

Fulltext Access 12 Pages 2017

Discrete element analysis of gothic masonry vaults for self-weight and horizontal support displacement

Fulltext Access 15 Pages 2017

Component model for pull-out behaviour of headed anchored blind bolt within concrete filled circular hollow section

Fulltext Access 15 Pages 2017

Prediction of long-term extreme load effects due to wind for cable-supported bridges using time-domain simulations

Fulltext Access 15 Pages 2017

Operational modal analysis of an end-supported pontoon bridge

Fulltext Access 14 Pages 2017

Flexural strength-ductility assessment of unreinforced masonry cross-sections: analytical expressions

Fulltext Access 11 Pages 2017

Numerical study on the seismic performance of precast segmental concrete columns under cyclic loading

Fulltext Access 14 Pages 2017

Investigation on wind tunnel tests of the Kilometer skyscraper

Fulltext Access 17 Pages 2017

Experimental and numerical vibration analysis of wire rope isolators under quasi-static and dynamic loadings

Fulltext Access 12 Pages 2017

Comparison of available shear strength models for non-conforming reinforced concrete columns

Fulltext Access 16 Pages 2017

Assessing the pry-out resistance of open rib shear connectors in cracked concrete - Engineering model with aggregate interlock

Fulltext Access 9 Pages 2017

Estimating the response of steel structures subjected to vertical seismic excitation: Idealized model and inelastic displacement ratio

Fulltext Access 14 Pages 2017

Cyclic testing of steel beam blind bolted to CFST column composite frames with SBTD concrete slabs

Fulltext Access 19 Pages 2017

Bridge classes for regional seismic risk assessment: Improving HAZUS models

Fulltext Access 12 Pages 2017

Required proof load magnitude for probabilistic field assessment of viaduct De Beek

Fulltext Access 13 Pages 2017

Effect of constitutive models on the seismic response of an SMA-LRB isolated highway bridge

Fulltext Access 13 Pages 2017

Buckling behavior of 420 MPa HSSY columns: Test investigation and design approach

Fulltext Access 20 Pages 2017

Mechanical behaviour of concrete-filled CHS connections subjected to in-plane bending

Fulltext Access 12 Pages 2017

Bayesian approach to breathing crack detection in beam structures

Fulltext Access 10 Pages 2017

Dynamic characteristic of tall industrial chimney estimated from GPS measurement and frequency domain decomposition

Fulltext Access 16 Pages 2017

Load-resisting mechanisms of 3D composite floor systems under internal column-removal scenario

Fulltext Access 16 Pages 2017

A new active learning method based on the learning function U of the AK-MCS reliability analysis method

Fulltext Access 10 Pages 2017

Finite element analysis of concrete-filled steel tube (CFST) columns with circular sections under eccentric load

Fulltext Access 12 Pages 2017

An innovative I-beam to hybrid fabricated column connection: Experimental investigation

Fulltext Access 17 Pages 2017

Simplified model for compressive response of RC column footing with square cross-section

Fulltext Access 13 Pages 2017