Evaluating the crystallization of lactose at different cooling rates from milk and whey permeates in terms of crystal yield and purity

The cooling rate of supersaturated lactose solution is one of the important parameters determining the yield and size distribution of lactose crystals. The influence of increasing cooling rate on lactose crystallization and quality of lactose crystals was evaluated in concentrated solutions prepared from deproteinized whey powder (DPW) and milk permeate powder (MPP). Concentrated permeates (DPW and MPP) with 60% (wt/wt) total solids were prepared by reconstituting permeate powders in water at 80°C for 2 h for lactose dissolution. Three cooling rates, 0.04°C/min (slow), 0.06°C/min (medium), and 0.08°C/min (fast) were studied in duplicate. A common rapid cooling step (80 to 60°C at 0.5°C/min) followed by slow, medium, and fast cooling rates were applied as per the experimental design from 60 to 20°C. After crystallization, the crystal slurry was centrifuged, washed with cold water, and dried. The dried lactose crystals were weighed to calculate the lactose yield. Final mean particle chord lengths were measured at the end of crystallization using focused beam reflectance measurement for slow, medium, and fast cooling rates, and observed to be not significantly different for DPW (27-33 µm) and MPP (31-34 µm) concentrates. Similarly, the lactose yield for slow, medium, and fast cooling rates in the DPW and MPP concentrates were in the range of 71 to 73% and 76 to 81%, respectively, and no significant difference between the 3 cooling rates was found. Qualitative analysis of dried lactose crystals exhibited no noticeable differences in the crystal purity with increasing cooling rate. This study evaluated the possibility of reducing the crystallization times by 8 h compared with current industrial practice without compromising the crystal yield and quality.