Preparation of thick-film LiNi1/3Co1/3Mn1/3O2 electrodes by aerosol deposition and its application to all-solid-state batteries

•Thick-films of LiNi1/3Co1/3Mn1/3O2 are prepared by aerosol deposition.•Nano-coating of Nb–O on starting powders is a key point to realize the thick-film electrode.•The film is formed on stainless-steel substrate, and charge–discharge reactions were tested.•All-solid-state battery with the thick-film electrode works well and repeat the charge–discharge reaction.

We prepared thick and dense-crystalline LiNi1/3Co1/3Mn1/3O2 (NMC) composite films at room temperature that can work well as cathodes in all-solid-state battery cells. The thick films were fabricated by aerosol deposition using NMC powder (D50 = 10.61 μm) as a source material. Commercially-obtained NMC powder did not form films at all on silicon wafer substrates, and cracking of the substrates was observed. However, a few tens of nanometer coating with amorphous niobium oxide resulted in the deposition of 7 μm-thick crystalline dense composite films. The films were successfully fabricated also on Li+-conductive glass-ceramic sheets with 150 μm in thickness, and all-solid-state batteries were fabricated. The solid-state battery provided a cathode-basis discharge capacity of 152 mAh g−1 (3.0–4.2 V, 0.025 C, 333 K) and repeated charge–discharge cycles for 20 cycles.