Article ID Journal Published Year Pages File Type
147614 Chemical Engineering Journal 2014 6 Pages PDF
Abstract

•Fine ZnO powder obtained from ZnS mechanosynthesis.•Crystalline structure, microstructure and morphology characterization of the produced powders.•Study of the conversions ZnS–ZnO.•Applicability to sulfur removal.

Fine ZnO powder with high sulfur capacity was prepared by mechanical alloying of Zn(s) + S(s) followed by an oxidation treatment under air at 700 °C. X-ray diffraction measurements coupled with other characterization techniques enabled us to study the conversion of ZnS into ZnO and vice versa. This ZnO powder was implemented for gas desulfurization. These tests were performed at 400 °C using an experimental setup monitoring the exhaust gas composition for a feed gas mixture N2/H2S with a H2S content of 1000 ppmv. The measured sulfur capacity was equal to 272 mg S/g adsorbent.

Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide

Related Topics
Physical Sciences and Engineering Chemical Engineering Chemical Engineering (General)
Authors
, , , , , ,