Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
2441141 | Journal of Dairy Science | 2007 | 12 Pages |
Abstract
Two sets of cheeses were evaluated to determine factors that affect shred quality. The first set of cheeses was made up of 3 commercial cheeses, Monterey Jack, Mozzarella, and process. The second set of cheeses was made up of 3 Mozzarella cheeses with varying levels of protein and fat at a constant moisture content. A shred distribution of long shreds, short shreds, and fines was obtained by shredding blocks of cheese in a food processor. A probe tack test was used to directly measure adhesion of the cheese to a stainless-steel surface. Surface energy was determined based on the contact angles of standard liquids, and rheological characterization was done by a creep and recovery test. Creep and recovery data were used to calculate the maximum and initial compliance and retardation time. Shredding defects of fines and adhesion to the blade were observed in commercial cheeses. Mozzarella did not adhere to the blade but did produce the most fines. Both Monterey Jack and process cheeses adhered to the blade and produced fines. Furthermore, adherence to the blade was correlated positively with tack energy and negatively with retardation time. Mozzarella cheese, with the highest fat and lowest protein contents, produced the most fines but showed little adherence to the blade, even though tack energy increased with fat content. Surface energy was not correlated with shredding defects in either group of cheese. Rheological properties and tack energy appeared to be the key factors involved in shredding defects.
Keywords
Related Topics
Life Sciences
Agricultural and Biological Sciences
Animal Science and Zoology
Authors
J.L. Childs, C.R. Daubert, L. Stefanski, E.A. Foegeding,