Multi-level quantization and blind equalization based direct transmission method of digital baseband signal

The direct transmission of digital baseband signals has practical significance in the field of Ethernet terminal connection, high-speed digital communication, data transmission of various types of information peripherals. The signal amplitude gradually decays while the transmission distance increases. Also the attenuation is proportional to the signal frequency, resulting in signal distortion and receiving error. It is a common method for digital baseband signal transmission to use pre-emphasis chip and equalizer chip to improve the transmission quality with a wide range of mature applications. This paper describes a new type of digital signal transmission method, as the receiver using analog-to-digital converter, instead of equalizer chip, to achieve the multi-level quantization of receiving time-domain data waveform. The waveform of the transmitted digital high and low level signal is sampled into multi-bit values. Then, the paper realizes adaptive frequency domain equalization based on soft threshold and makes use of multi-level quantization soft information for error correction. Error correcting code is mainly used to correct the error caused by the channel bandwidth limit, external noise or interference in the process of data transmission, so as to improve the stability and reliability of the transmission. The paper uses the two-stage error correcting codec system based on both Turbo and BCH coding, to achieve the high performance of Turbo code, and good characters of respond time and complexity. The transmitter outputs 12.5 MHz pseudo-random sequence through a 199.93 meter unshielded balanced twisted pair transmission medium. And the receiver circuit using a 62.5MSPS analog-to-digital converter over-samples the waveform to 8-level quantity. The output error of a 65536 bit pseudo-random sequence is less than 8 bits, and the error correction can be further improved by 8b-10b codec. Compared with the traditional pre-emphasis and balanced interface ICs connection, the method described in this article has the advantages of longer transmission distance, better flexibility and wider scope of use.