New encapsulation development for fine pitch IC devices

This paper presents a new encapsulation process development for 50 μm fine pitch plastic ball grid array package. Since reduced wire diameter decreases the bending strength of bonded wires significantly, wire deflection during molding process becomes quite serious and critical. Experiments on conventional transfer molding were conducted to evaluate wire span threshold with 23.0 μm diameter gold wire. The results show that the wire span threshold is about 4.1 mm, which is much shorter than the wire span threshold of over 5.0 mm for wire with 25.4 μm diameter. Finite element analysis shows there is a significant difference in the wire deflection between 23.0 μm gold wire and 25.4 μm gold wire diameter under the same action of mold flow. A novel encapsulation method is introduced using non-sweep solution. The wire span could be extended to over 5.0 mm with wire sweep less than 1%. Reliability tests conducted showed that all the units passed 1000 temperature cycles (−55 to 125 °C) with JEDEC moisture sensitivity level 2a (60 °C/60% relative humidity for 120 h) and 3 times reflow (peak temperature at 220-225 °C). It is believed that this solution could efficiently overcome the risk of wire short issues and improve the yield of ultra fine pitch wire bonds in high-volume production.