Correlation between the local climate and the free-cooling potential of latent heat storage Fulltext Access 9 Pages 2008
Analytical and semi-analytical solutions for short-time transient response of ground heat exchangers Fulltext Access 9 Pages 2008
Optimization of the configuration of 290 × 140 × 90 hollow clay bricks with 3-D numerical simulation by finite volume method Fulltext Access 9 Pages 2008
Performance and influence of numerical sub-models on the CFD simulation of free and forced convection in double-glazed ventilated façades Fulltext Access 9 Pages 2008
Thermal storage and nonlinear heat-transfer characteristics of PCM wallboard Fulltext Access 9 Pages 2008
Investigation of a windvent passive ventilation device against current fresh air supply recommendations Fulltext Access 9 Pages 2008
The effect of urban evaporation on building energy demand in an arid environment Fulltext Access 9 Pages 2008
Power output analysis of transparent thin-film module in building integrated photovoltaic system (BIPV) Fulltext Access 9 Pages 2008
Development of an adaptive Smith predictor-based self-tuning PI controller for an HVAC system in a test room Fulltext Access 9 Pages 2008
Comparison of thermal comfort algorithms in naturally ventilated office buildings Fulltext Access 9 Pages 2008
Advanced compact device for the in situ determination of geothermal characteristics of soils Fulltext Access 9 Pages 2008
Performance study of underground thermal storage in a solar-ground coupled heat pump system for residential buildings Fulltext Access 9 Pages 2008
Verification of energy efficiency of district heating and cooling system by simulation considering design and operation parameters Fulltext Access 9 Pages 2008
Levels and distribution of organochlorine pesticides in shellfish from Qiantang River, China Fulltext Access 9 Pages 2008
A novel method to enhance polychlorinated dibenzo-p-dioxins and dibenzofurans removal by adding bio-solution in EAF dust treatment plant Fulltext Access 9 Pages 2008
Decomposition kinetics of ammonia in gaseous stream by a nanoscale copper-cerium bimetallic catalyst Fulltext Access 9 Pages 2008
TiO2 hydrosols with high activity for photocatalytic degradation of formaldehyde in a gaseous phase Fulltext Access 9 Pages 2008
Adsorption of 4-nitrophenol onto Amberlite® IRA-900 modified with metallophthalocyanines Fulltext Access 9 Pages 2008
The formation and distribution of haloacetic acids in copper pipe during chlorination Fulltext Access 9 Pages 2008
Prediction of ion-exchange column breakthrough curves by constant-pattern wave approach Fulltext Access 9 Pages 2008
Analysis of dechlorination kinetics of chlorinated aliphatic hydrocarbons by Fe(II) in cement slurries Fulltext Access 9 Pages 2008
Characteristics and treatability of oil-bearing wastes from aluminum alloy machining operations Fulltext Access 9 Pages 2008
Energetic efficiency of room wall containing PCM wallboard: A full-scale experimental investigation Fulltext Access 9 Pages 2008
Heat supply to low-energy buildings in district heating areas: Analyses of CO2 emissions and electricity supply security Fulltext Access 9 Pages 2008
Thermotropic glass with active dimming control for solar shading and daylighting Fulltext Access 9 Pages 2008
CO2-dispersion studies in an operation theatre under transient conditions Fulltext Access 9 Pages 2008
A computational method to assess the impact of urban climate on buildings using modeled climatic data Fulltext Access 9 Pages 2008
An applied artificial intelligence approach towards assessing building performance simulation tools Fulltext Access 9 Pages 2008
Hydrous ferric oxide as an adsorbent in water treatment: Part 1. Preparation and physical characterization Fulltext Access 9 Pages 2008
Measurement system for long-term recording of wood moisture content with internal conductively glued electrodes Fulltext Access 9 Pages 2008
Experimental and theoretical investigation of non-isothermal transfer in hygroscopic building materials Fulltext Access 9 Pages 2008
Preliminary risk assessment of ecotoxic substances accidental releases in major risk installations through fuzzy logic Fulltext Access 9 Pages 2008
Consequence analysis by means of characteristic curves to determine the damage to humans from bursting spherical vessels Fulltext Access 9 Pages 2008
Influence of clay mineral structure and surfactant nature on the adsorption capacity of surfactants by clays Fulltext Access 9 Pages 2008
Optimization of process parameters for acrylonitrile removal by a low-cost adsorbent using Box-Behnken design Fulltext Access 9 Pages 2008
Direct determination of tidal levels for engineering applications based on biological observations Fulltext Access 9 Pages 2008
Concretes with aggregates from demolition waste and silica fume. Materials and mechanical properties Fulltext Access 9 Pages 2008
Lagrangian measurements and modelling of fluid advection in the inner surf and swash zones Fulltext Access 9 Pages 2008
Tidal and surge modelling using differential quadrature: A case study in the Bristol Channel Fulltext Access 9 Pages 2008
Reflected and transmitted waves in a channel with side porous mattresses Fulltext Access 9 Pages 2008
Maximum run-up, breaking conditions and dynamical forces in the swash zone: a boundary value approach Fulltext Access 9 Pages 2008
Analysis of domestic hot water energy consumption in large buildings under standard conditions in Senegal Fulltext Access 9 Pages 2008
Heterogeneous photocatalytic removal of toluene from air on building materials enriched with TiO2 Fulltext Access 9 Pages 2008
Comparison of strategies to improve indoor air quality at the pre-occupancy stage in new apartment buildings Fulltext Access 9 Pages 2008
A new approach on zonal modeling of indoor environment with mechanical ventilation Fulltext Access 9 Pages 2008
Thermoeconomic analysis of energy utilization in the residential–commercial sector: An application Fulltext Access 9 Pages 2008
Thermal, moisture and microbiological boundary conditions of slab-on-ground structures in cold climate Fulltext Access 9 Pages 2008
Estimating sediment yield from a forest road network by using a sediment prediction model and GIS techniques Fulltext Access 9 Pages 2008
Semi-analytical solution of roof-on-grade attached underground engineering envelope Fulltext Access 9 Pages 2008
Unitary management and environmental performance by monitoring and protection of mineral resources for construction materials from Romania Fulltext Access 9 Pages 2008
Experimental energy and exergy analysis of a double-flow solar air heater having different obstacles on absorber plates Fulltext Access 9 Pages 2008
Effect of stove asymmetric radiation field on thermal comfort using a multisegmented bioheat model Fulltext Access 9 Pages 2008
Predicting diffuse illuminance on vertical surfaces at Arcavacata di Rende (Italy) for various types of sky Fulltext Access 9 Pages 2008
The effect of bedform dynamics on computing suspended sediment fluxes using optical backscatter sensors and current meters Fulltext Access 10 Pages 2008
Sensitivity of wave model predictions to wind fields in the Western Mediterranean sea Fulltext Access 10 Pages 2008
Three-dimensional nonlinear random wave groups in intermediate water depth Fulltext Access 10 Pages 2008
Submarine debris flow impact on pipelines — Part I: Experimental investigation Fulltext Access 10 Pages 2008
The morphological response of a nearshore double sandbar system to constant wave forcing Fulltext Access 10 Pages 2008
On the contribution of the scales of mixing to the oxygen transfer in stirred tanks Fulltext Access 10 Pages 2008
Prediction of the spray scrubbers’ performance in the gaseous and particulate scrubbing processes Fulltext Access 10 Pages 2008
Axial voidage profiles and identification of flow regimes in the riser of a circulating fluidized bed Fulltext Access 10 Pages 2008
High yield epoxidation of fatty acid methyl esters with performic acid generated in situ Fulltext Access 10 Pages 2008
Adsorption isotherm, kinetic modeling and mechanism of 2,4,6-trichlorophenol on coconut husk-based activated carbon Fulltext Access 10 Pages 2008
Synthesis gas generation by chemical-looping reforming in a batch fluidized bed reactor using Ni-based oxygen carriers Fulltext Access 10 Pages 2008
Thermodynamic analysis of a reactive distillation process for deep hydrodesulfurization of diesel: Effect of the solvent and operating conditions Fulltext Access 10 Pages 2008
Kinetic and microstructural study of the continuous emulsion polymerization of an all-acrylics formulation in the loop reactor Fulltext Access 10 Pages 2008
Removal of arsenic and sulphate from the copper smelting industrial effluent Fulltext Access 10 Pages 2008
A realistic approach to modeling an in-duct desulfurization process based on an experimental pilot plant study Fulltext Access 10 Pages 2008
Enhancement effect of water on oxidation reactions over commercial three-way catalyst Fulltext Access 10 Pages 2008
Modelling accidental releases of dangerous gases into the lower troposphere from mobile sources Fulltext Access 10 Pages 2008
Modeling of a bacterial and fungal biofilter applied to toluene abatement: Kinetic parameters estimation and model validation Fulltext Access 10 Pages 2008
Phase equilibrium studying for the supercritical fluid extraction process using carbon dioxide solvent with 1.35 mole ratio of octane to ethanol mixture Fulltext Access 10 Pages 2008
Enhanced fluoride removal from drinking water by magnesia-amended activated alumina granules Fulltext Access 10 Pages 2008
Impact of mass transfer coefficient correlations on prediction of reactive distillation column behaviour Fulltext Access 10 Pages 2008
A model for the pressure balance of a low density circulating fluidized bed Fulltext Access 10 Pages 2008
Hydrous ferric oxide as an adsorbent in water treatment: Part 2. Adsorption studies Fulltext Access 10 Pages 2008
Hydrous ferric oxide as an adsorbent in water treatment: Part 3: Batch and mini-column adsorption of arsenic, phosphorus, fluorine and cadmium ions Fulltext Access 10 Pages 2008
Some observations on explosion development in process pipelines and implications for the selection and testing of explosion protection devices Fulltext Access 10 Pages 2008