Reduction of equivalent continuous A-weighted sound pressure levels by porous elastic road surfaces Fulltext Access 13 Pages 2005
Use of turbines for simultaneous pressure regulation and recovery in secondary cooling water systems in deep mines Fulltext Access 13 Pages 2005
The Brazilian air transportation sector in the context of global climate change: CO2 emissions and mitigation alternatives Fulltext Access 13 Pages 2005
Simulation of CO2 capture using MEA scrubbing: a flowsheet decomposition method Fulltext Access 13 Pages 2005
The UK noise climate 1990-2001: population exposure and attitudes to environmental noise Fulltext Access 13 Pages 2005
Sound field of a baffled sound source covered by an anisotropic rigid-porous material Fulltext Access 13 Pages 2005
On the optimization of ultra low power front-end interfaces for capacitive sensors Fulltext Access 13 Pages 2005
Linear μ-bending method for the measurement of the residual stress of surface-micromachined MEMS Fulltext Access 13 Pages 2005
Intelligent actuation strategy for a three-DOF four-wire type optical pickup Fulltext Access 13 Pages 2005
Engine and winter road test performances of used cooking oil originated biodiesel Fulltext Access 13 Pages 2005
Study of a H2 separating membrane reactor for methane steam reforming at conditions relevant for power processes with CO2 capture Fulltext Access 13 Pages 2005
Effects of viscous dissipation on the heat transfer in forced pipe flow. Part 1: both hydrodynamically and thermally fully developed flow Fulltext Access 13 Pages 2005
Mode-I fracture toughness testing of thick section FRP composites using the ESE(T) specimen Fulltext Access 13 Pages 2005
The effect of crack surface interaction on the stress intensity factor in Mode III crack growth in round shafts Fulltext Access 13 Pages 2005
Thermomechanical analysis of thermal shock fracture in the brittle/ductile transition zone. Part I: description of tests Fulltext Access 13 Pages 2005
The use of fracture mechanics in failure analysis in the offshore diamond mining industry Fulltext Access 13 Pages 2005
Regarding the relation between the NOx content and CO content in thermo power plants flue gases Fulltext Access 13 Pages 2005
The effect of heat transfer on performance of the Diesel cycle and exergy of the exhaust gas stream in a LHR Diesel engine at the optimum injection timing Fulltext Access 13 Pages 2005
Experimental study on split air conditioner with new hybrid equipment of energy storage and water heater all year round Fulltext Access 13 Pages 2005
A continuous efficiency optimization controller for induction motor drives Fulltext Access 13 Pages 2005
Using CaO- and MgO-rich industrial waste streams for carbon sequestration Fulltext Access 13 Pages 2005
Analysis of the component characteristics of air-cooled chillers for modelling floating condensing temperature control Fulltext Access 13 Pages 2005
Experimental evaluation of buildings damaged in recent earthquakes in Turkey Fulltext Access 13 Pages 2005
Gas fired combined cycle plant in Singapore: energy use, GWP and cost—a life cycle approach Fulltext Access 13 Pages 2005
Design and simulation of a low concentrating photovoltaic/thermal system Fulltext Access 13 Pages 2005
Decentralized/stand-alone hybrid Wind–Diesel power systems to meet residential loads of hot coastal regions Fulltext Access 13 Pages 2005
Numerical analysis of a PCM thermal storage system with varying wall temperature Fulltext Access 13 Pages 2005
A comparative study of adaptive load frequency controller designs in a power system with dynamic neural network models Fulltext Access 13 Pages 2005
Effects of operating parameters on the combustion of medical waste in a controlled air incinerator Fulltext Access 13 Pages 2005
Development and testing of a domestic woodstove thermoelectric generator with natural convection cooling Fulltext Access 13 Pages 2005
Hydropyrolysis of a Turkish lignite (Tunçbilek) and effect of temperature and pressure on product distribution Fulltext Access 13 Pages 2005
Formulation of semi-empirical models for predicting the illuminance of light pipes Fulltext Access 13 Pages 2005
Design and fabrication of a hybrid silicon three-axial force sensor for biomechanical applications Fulltext Access 13 Pages 2005
Comparison of Shell, Texaco, BGL and KRW gasifiers as part of IGCC plant computer simulations Fulltext Access 13 Pages 2005
Short term and medium term power distribution load forecasting by neural networks Fulltext Access 13 Pages 2005
Dynamic axial crack propagation in steel line pipes. Part II: Theoretical developments Fulltext Access 14 Pages 2005
Crack tip opening displacement in micro-cracked concrete by an embedded optical fiber sensor Fulltext Access 14 Pages 2005
Fracture instability and limit strength condition in structures with re-entrant corners Fulltext Access 14 Pages 2005
The boundary finite element method for predicting directions of cracks emerging from notches at bimaterial junctions Fulltext Access 14 Pages 2005
Numerical experimental study on the 3-D flow field around a van with a dome for energy saving Fulltext Access 14 Pages 2005
Experimental study of the characteristics of solidification of stearic acid in an annulus and its thermal conductivity enhancement Fulltext Access 14 Pages 2005
Influence of intermittent heat source on adsorption ice maker using waste heat Fulltext Access 14 Pages 2005
Characterization of burning and CO2 gasification of chars from mixtures of Zonguldak (Turkey) and Australian bituminous coals Fulltext Access 14 Pages 2005
Development of specimen and test method for strength analysis of MEMS micromirror Fulltext Access 14 Pages 2005
Investigation of applicability of the various adsorption models of methylene blue adsorption onto lignite/water interface Fulltext Access 14 Pages 2005
Exergetic analysis of a double stage LiBr-H2O thermal compressor cooled by air/water and driven by low grade heat Fulltext Access 14 Pages 2005
A new approach using artificial neural networks for determination of the thermodynamic properties of fluid couples Fulltext Access 14 Pages 2005
An experimental study on performance and exhaust emissions of a diesel engine fuelled with tobacco seed oil methyl ester Fulltext Access 14 Pages 2005
Laminar film condensation on an elliptical tube embedded in porous media Fulltext Access 14 Pages 2005
Strain energy release rates for an interface crack in orthotropic media--a finite element investigation Fulltext Access 14 Pages 2005
Transient pattern analysis for fault detection and diagnosis of HVAC systems Fulltext Access 14 Pages 2005
Global optimization for overall HVAC systems--Part II problem solution and simulations Fulltext Access 14 Pages 2005
Fuzzy control with random delays using invariant cones and its application to control of energy processes in microelectromechanical motion devices Fulltext Access 14 Pages 2005
Applying proper orthogonal decomposition to the computation of particle dispersion in a two-dimensional ventilated cavity Fulltext Access 14 Pages 2005
Influence of fuel additives on performance of direct-injection Diesel engine and exhaust emissions when operating on shale oil Fulltext Access 14 Pages 2005
A hardware development for optical tomography system using switch mode fan beam projection Fulltext Access 14 Pages 2005
Micropyrotechnics, a new technology for making energetic microsystems: review and prospective Fulltext Access 14 Pages 2005
A factorial analysis for the determination of an optimal train speed with a desired ride comfort Fulltext Access 14 Pages 2005
Sound intensity investigation of the acoustics performances of high insulation ventilating windows integrated with rolling shutter boxes Fulltext Access 14 Pages 2005
Fabrication of vertical digital silicon optical micromirrors on suspended electrode for guided-wave optical switching applications Fulltext Access 14 Pages 2005
Hybrid fuzzy controller for speed control of switched reluctance motor drives Fulltext Access 14 Pages 2005
High-rate J-testing of toughened polyamide 6/6: Applicability of the load separation criterion and the normalization method Fulltext Access 14 Pages 2005
Prediction of homogeneous shear flow and a backward-facing step flow with some linear and non-linear K-ε turbulence models Fulltext Access 14 Pages 2005
Sound scattering by a resistive and axially symmetric object in a two-layer ocean Fulltext Access 14 Pages 2005
Some new approaches to building and implementation of wall-functions for modeling of near-wall turbulent flows Fulltext Access 14 Pages 2005
Theoretical and experimental studies of water injection scroll compressor in automotive fuel cell systems Fulltext Access 14 Pages 2005
Evaluation of R-curve behavior of ceramic–metal functionally graded materials by stable crack growth Fulltext Access 14 Pages 2005
Stress intensity factors of semi-elliptical surface cracks in pressure vessels by global-local finite element methodology Fulltext Access 14 Pages 2005
Microstructural aspects of the failure analysis of nickel base superalloys components Fulltext Access 14 Pages 2005
Stress intensity factors for cracks emanating from a triangular or square hole in an infinite plate by boundary elements Fulltext Access 14 Pages 2005