Optimisation of a stamping process by a design of experiment linked to a modal analysis of geometric defects Fulltext Access 13 Pages 2006
Synergistic inhibition between o-phenanthroline and chloride ion for steel corrosion in sulphuric acid Fulltext Access 14 Pages 2006
Phase behavior and microstructural length scales of a diblock copolymer in the presence of a selective solvent Fulltext Access 14 Pages 2006
On the characterization of tensile creep resistance of polyamide 66 nanocomposites. Part II: Modeling and prediction of long-term performance Fulltext Access 14 Pages 2006
A QM/MM study of the ethylene and styrene insertion process into the ion pair [Me2Si(C5Me4)(NtBu)Ti(CH2CH2CH3)]+[μ-Me-Al(Me)2-(AlOMe)6Me]â Fulltext Access 14 Pages 2006
Synthesis and characterization of biodegradable non-toxic poly(ester-urethane-urea)s based on poly(ε-caprolactone) and amino acid derivatives Fulltext Access 14 Pages 2006
Morphology and properties of thermoplastic polyurethane nanocomposites: Effect of organoclay structure Fulltext Access 14 Pages 2006
Physical properties of poly(n-alkyl acrylate) copolymers. Part 2. Crystalline/non-crystalline combinations Fulltext Access 14 Pages 2006
The role of clay network on macromolecular chain mobility and relaxation in isotactic polypropylene/organoclay nanocomposites Fulltext Access 14 Pages 2006
Effect of tin on high-temperature sulphidation of Fe–Cr alloys in H2/H2S atmospheres Fulltext Access 14 Pages 2006
Atomic-scale structure of β-FeOOH containing chromium by anomalous X-ray scattering coupled with reverse Monte Carlo simulation Fulltext Access 14 Pages 2006
Influence of H2–N2 atmosphere composition and annealing duration on the selective surface oxidation of low-carbon steels Fulltext Access 14 Pages 2006
Intergranular corrosion damage evaluation through laser scattering technique Fulltext Access 14 Pages 2006
Time-resolved SAXS studies on ordering kinetics of block copolymers: Further investigation of two-step ordering from disorder-sphere to hex-cylinder Fulltext Access 14 Pages 2006
Modelling the corrosion behaviour of Al2CuMg coarse particles in copper-rich aluminium alloys Fulltext Access 14 Pages 2006
Mass-balance and Eh–pH diagrams of FeII–III green rust in aqueous sulphated solution Fulltext Access 14 Pages 2006
Evaluation of impedance measurements on mild steel corrosion in acid media in the presence of heterocyclic compounds Fulltext Access 14 Pages 2006
Structure and composition of artificially synthesized rusts of Zn–Fe and Zn–Ti alloys Fulltext Access 14 Pages 2006
Influence of Ce surface treatments on corrosion behaviour of A3xx.x/SiCp composites in 3.5Â wt.% NaCl Fulltext Access 14 Pages 2006
Composition and protective ability of rust layer formed on weathering steel exposed to various environments Fulltext Access 14 Pages 2006
Electrochemical behavior and localized corrosion associated with Al7Cu2Fe particles in aluminum alloy 7075-T651 Fulltext Access 14 Pages 2006
Stabilization of γ-sterilized biomedical polyolefins by synergistic mixtures of oligomeric stabilizers Fulltext Access 14 Pages 2006
Adsorption characteristics of metal complexes by chelated copolymers with amino group Fulltext Access 14 Pages 2006
Analytical evaluation of stereoregularity in poly(2-N-carbazolylethyl methacrylate) by two-dimensional NMR spectroscopy Fulltext Access 14 Pages 2006
Synthesis, ion exchange properties and analytical applications of stannic silicomolybdate: Effect of temperature on distribution coefficients of metal ions Fulltext Access 14 Pages 2006
Investigation of water uptake behavior and stability of calcium alginate/chitosan bi-polymeric beads: Part-1 Fulltext Access 14 Pages 2006
Electrochemical oxidative polymerization of sodium 4-amino-3-hydroxynaphthalene-1-sulfonate and structural characterization of polymeric products Fulltext Access 14 Pages 2006
Electric field induced stress moduli in polythiophene/polyisoprene elastomer blends Fulltext Access 14 Pages 2006
Synthesis and properties of new N-(2-hydroxypropyl)methacrylamide copolymers containing thiazolidine-2-thione reactive groups Fulltext Access 14 Pages 2006
Fluorescently tagged star polymers by living radical polymerisation for mucoadhesion and bioadhesion Fulltext Access 14 Pages 2006
Material parameters for the evaluation of PA welds using laser extensometry Fulltext Access 14 Pages 2006
Effect of heat flux on the burning behaviour of foam and foam/Nomex III fabric combination in the cone calorimeter Fulltext Access 14 Pages 2006
Physico-chemical aspects of polyethylene processing in an open mixer. Part 24: Experimental kinetics of aldehyde and carboxylic acid formation Fulltext Access 14 Pages 2006
Evaluation of polymers for conservation treatments of outdoor exposed stone monuments. Part I: Photo-oxidative weathering Fulltext Access 14 Pages 2006
Structural and physico-chemical studies on modification of polypropylene and its polyphenolic antioxidant by electron beam irradiation Fulltext Access 14 Pages 2006
Physico-chemical aspects of polyethylene processing in an open mixer. Part 23: Mechanisms and kinetics of trans-vinylene group consumption Fulltext Access 14 Pages 2006
Effect of compatibilisers on mechanical and thermal properties of bentonite filled polypropylene composites Fulltext Access 14 Pages 2006
A new multiscale modeling approach for the prediction of mechanical properties of polymer-based nanomaterials Fulltext Access 14 Pages 2006
Influence of the oxidation state of phosphorus on the decomposition and fire behaviour of flame-retarded epoxy resin composites Fulltext Access 14 Pages 2006
Influence of molecular composition on the development of microstructure from sheared polyethylene melts: Molecular and lamellar templating Fulltext Access 14 Pages 2006
Properties and morphology of nanocomposites based on styrenic polymers. Part I: Styrene-acrylonitrile copolymers Fulltext Access 14 Pages 2006
On significant retention of impact strength in clay-reinforced high-density polyethylene (HDPE) nanocomposites Fulltext Access 14 Pages 2006
Combined MALDI-TOF MS and NMR characterization of copoly(arylen ether sulphone)s Fulltext Access 14 Pages 2006
Theoretical calculation on the membrane potential of charged porous membranes in 1-1, 1-2, 2-1 and 2-2 electrolyte solutions Fulltext Access 14 Pages 2006
Prediction of mechanical stresses induced by flip-chip underfill encapsulants during cure Fulltext Access 14 Pages 2006
Effect of water content on transparency, swelling, lidocaine diffusion in p-HEMA gels Fulltext Access 14 Pages 2006
Vibratory shear enhanced processing membrane filtration applied for the removal of natural organic matter from surface waters Fulltext Access 14 Pages 2006
Separation of organic mixtures by pervaporation using crosslinked rubber membranes Fulltext Access 14 Pages 2006
A theoretical and experimental analysis of a membrane bioreactor performance in recycle configuration Fulltext Access 14 Pages 2006
Sodium montmorillonite clay loaded novel mixed matrix membranes of poly(vinyl alcohol) for pervaporation dehydration of aqueous mixtures of isopropanol and 1,4-dioxane Fulltext Access 14 Pages 2006
Understanding the relationship between silane application conditions, bond durability and locus of failure Fulltext Access 14 Pages 2006
General solution for the time lag of a single-tank receiver in the Knudsen flow regime and its implications for the receiver's configuration Fulltext Access 14 Pages 2006
Study on a novel polyamide-urea reverse osmosis composite membrane (ICIC-MPD): II. Analysis of membrane antifouling performance Fulltext Access 14 Pages 2006
Mass, charge and energy transport phenomena in a polymer electrolyte membrane (PEM) used in a direct methanol fuel cell (DMFC): Modelling and experimental validation of fluxes Fulltext Access 14 Pages 2006
Diagnostic characterization of gypsum scale formation and control in RO membrane desalination of brackish water Fulltext Access 14 Pages 2006
Mathematical modeling of fluid and solute transport in hemodialysis and peritoneal dialysis Fulltext Access 14 Pages 2006
Electrochemical behavior of multicomponent amorphous and nanocrystalline Zr-based alloys in different environments Fulltext Access 14 Pages 2006
A novel accelerated corrosion test for exhaust systems by means of power ultrasound Fulltext Access 14 Pages 2006
Atmospheric corrosion of carbon steel under field exposure in the southern part of Vietnam Fulltext Access 14 Pages 2006
Atom probe field ion microscope measurements of carbon segregation at an α:α grain boundary and service failures by intergranular stress corrosion cracking Fulltext Access 14 Pages 2006
Novel corrosion experiments using the wire beam electrode: (III) Measuring electrochemical corrosion parameters from both the metallic and electrolytic phases Fulltext Access 14 Pages 2006
Novel corrosion experiments using the wire beam electrode: (II) Monitoring the effects of ions transportation on electrochemical corrosion processes Fulltext Access 14 Pages 2006
Comparative study of the behaviour of AISI 304 SS in a natural seawater hopper, in sterile media and with SRB using electrochemical techniques and SEM Fulltext Access 14 Pages 2006
Stress corrosion cracking of B13, a new high strength aluminium lithium alloy Fulltext Access 14 Pages 2006
Determination of the critical hydrogen concentration for delayed fracture of high strength steel by constant load test and numerical calculation Fulltext Access 14 Pages 2006
Electrochemical reduction of ferric corrosion products and evaluation of galvanic coupling with iron Fulltext Access 14 Pages 2006
Corrosion properties of plasma nitrided AISI 410 martensitic stainless steel in 3.5% NaCl and 1% HCl aqueous solutions Fulltext Access 14 Pages 2006
Electrochemical behavior of copper–nickel alloys in acidic chloride solutions Fulltext Access 14 Pages 2006
Electrochemical behavior of tin in sodium borate solutions and the effect of halide ions and some inorganic inhibitors Fulltext Access 14 Pages 2006
A novel fluorescent, conducting polymer: Poly[1-(thiophene-2-yl)benzothieno[3,2-b]benzothiophene] electrosynthesis, characterization and optical properties Fulltext Access 14 Pages 2006
Preparation and characterization of composite palladium membranes on sinter-metal supports with a ceramic barrier against intermetallic diffusion Fulltext Access 15 Pages 2006
Pervaporation and related properties of time-dependent growth layers of zeolite NaA on structured ceramic supports Fulltext Access 15 Pages 2006
Irreversible thermodynamics and overall mass transport in ion-exchange membrane electrodialysis Fulltext Access 15 Pages 2006
Fatigue life of reinforced concrete beams under bending strengthened with composite materials Fulltext Access 15 Pages 2006
Characterization of membrane distillation modules and analysis of mass flux enhancement by channel spacers Fulltext Access 15 Pages 2006
Process and equipment design for membrane-based extraction: Basic considerations Fulltext Access 15 Pages 2006
Visualisation of fouling during microfiltration of natural brown water by using wavelets of ultrasonic spectra Fulltext Access 15 Pages 2006
Morphology and mechanical properties of polyamide 12/polypropylene blends in presence and absence of reactive compatibiliser Fulltext Access 15 Pages 2006
Preparation of interconnected poly(ε-caprolactone) porous scaffolds by a combination of polymer and salt particulate leaching Fulltext Access 15 Pages 2006
Elastomer particle morphology in ternary blends of maleated and non-maleated ethylene-based elastomers with polyamides: Role of elastomer phase miscibility Fulltext Access 15 Pages 2006
Blown films of nanocomposites prepared from low density polyethylene and a sodium ionomer of poly(ethylene-co-methacrylic acid) Fulltext Access 15 Pages 2006
Microstructural features, diffusion and molecular relaxations in polyimide/silica hybrids Fulltext Access 15 Pages 2006
Performance of treated and untreated asymmetric polysulfone hollow fiber membrane in series and cascade module configurations for CO2/CH4 gas separation system Fulltext Access 15 Pages 2006
Post-lens tear-film depletion due to evaporative dehydration of a soft contact lens Fulltext Access 15 Pages 2006
Effect of copolymer type and composition on separation characteristics of pervaporation membranes—A case study with separation of acetone–water mixtures Fulltext Access 15 Pages 2006
Phase field simulations of early stage structure formation during immersion precipitation of polymeric membranes in 2D and 3D Fulltext Access 15 Pages 2006
Experimental–numerical studies of transverse impact response of adhesively bonded lap joints in composite structures Fulltext Access 15 Pages 2006