Characteristics of atmospheric pressure N2 cold plasma torch using 60-Hz AC power and its application to polymer surface modification Fulltext Access 6 Pages 2005
Preparation, microstructure and tribological properties of nano-Al2O3/Ni brush plated composite coatings Fulltext Access 6 Pages 2005
Microstructure and wear behaviours of laser-clad Cr13Ni5Si2-based metal-silicide coatings on a titanium alloy Fulltext Access 6 Pages 2005
Stripping of Zn-Ni alloys deposited in acetate-chloride electrolyte under potentiodynamic and galvanostatic conditions Fulltext Access 6 Pages 2005
Evaluation of the electrochemical behavior of HVOF-sprayed alloy coatings-II Fulltext Access 6 Pages 2005
Relationship between through-thickness residual stress of CrN-PVD coatings and fatigue nucleation sites Fulltext Access 6 Pages 2005
Influences of the nitrogen content on the morphological, chemical and optical properties of pulsed laser deposited silicon nitride thin films Fulltext Access 6 Pages 2005
Microstructure and fracture strength of different grades of freestanding diamond films deposited by a DC Arc Plasma Jet process Fulltext Access 6 Pages 2005
Determination of proof stress and strain-hardening exponent for thin film with biaxial residual stresses by in-situ XRD stress analysis combined with tensile test Fulltext Access 6 Pages 2005
Improvement of fibroblast adherence to titanium surface by calcium phosphate coating formed with IBAD Fulltext Access 6 Pages 2005
Investigation of plasma oxynitridation of Si(001) by NH3/N2O/Ar remote plasma processing Fulltext Access 6 Pages 2005
Synthesis of WC-Ni films using an arc ion plating system with attached solenoid coil Fulltext Access 6 Pages 2005
Application of the duplex TiN coatings to improve the tribological properties of Electro Hydrostatic Actuator pump parts Fulltext Access 6 Pages 2005
Cutting performance of Ti-Al-Si-N-coated tool by a hybrid-coating system for high-hardened materials Fulltext Access 6 Pages 2005
A study of plasma oxidation effects on the passive layer synthesis for the corrosion resistance of (α+β) brass Fulltext Access 6 Pages 2005
Properties of TiAlN coatings synthesized by closed-field unbalanced magnetron sputtering Fulltext Access 6 Pages 2005
Structural analysis of (Cr1âxSix)N coatings and tribological property in water environment Fulltext Access 6 Pages 2005
Ductile-brittle transition behaviors for the W-films-deposited stainless steel before and after hydrogen ion irradiation Fulltext Access 6 Pages 2005
The effect of thickness on the properties of Ti-doped ZnO films by simultaneous r.f. and d.c. magnetron sputtering Fulltext Access 6 Pages 2005
Controlling the growth of CVD carbon from methane on transition metal substrates Fulltext Access 6 Pages 2005
The effect of plasma spraying power on the structure and mechanical properties of hydroxyapatite deposited onto carbon/carbon composites Fulltext Access 6 Pages 2005
Effect of La2O3 on resistance to high-temperature oxidation of laser clad ferrite-based alloy coatings Fulltext Access 6 Pages 2005
Measurement of residual stresses by X-ray diffraction techniques in MoN and Mo2N coatings deposited by arc PVD on high-speed steel substrate Fulltext Access 6 Pages 2005
Laser cladding of stainless steel with Ni-Cr3C2 and Ni-WC for improving erosive-corrosive wear performance Fulltext Access 6 Pages 2005
Microstructure and mechanical properties of hard carbon films prepared by heat treatment of a polymer on steel substrate Fulltext Access 6 Pages 2005
Nano-grain structure of nickel films prepared by emulsion plating using dense carbon dioxide Fulltext Access 6 Pages 2005
The effect of solid diffusion surface alloying on properties of ZM5 magnesium alloy Fulltext Access 6 Pages 2005
Adhesion properties of Cu/Cr films on polyimide substrate treated by dielectric barrier discharge plasma Fulltext Access 6 Pages 2005
The growth mechanism of pits in NaCl solution under anodic films on aluminum Fulltext Access 6 Pages 2005
Fluorinated amorphous diamond-like carbon films deposited by plasma-enhanced chemical vapor deposition Fulltext Access 6 Pages 2005
Electrochemical stability of magnetron-sputtered Ti films on sintered and sintered/plasma nitrided Fe-1.5% Mo alloy Fulltext Access 6 Pages 2005
Low temperature plasma nitrocarburising of AISI 316 austenitic stainless steel Fulltext Access 6 Pages 2005
Multilayered microstructure of a Pb-Sn alloy coating obtained by electrochemical deposition Fulltext Access 6 Pages 2005
Relationship between photocatalytic activity, hydrophilicity and self-cleaning effect of TiO2/SiO2 films Fulltext Access 6 Pages 2005
Interfacial reactions during IBAD and their effects on the adhesion of Cr-N coatings on steel Fulltext Access 6 Pages 2005
Surface morphology of a laser surface nitrided and etched Ti-6Al-4V alloy Fulltext Access 6 Pages 2005
Research and development of oxidation, wear and corrosion resistant materials at high temperature by surface modification using ion processing Fulltext Access 6 Pages 2005
Evaluation of nanoparticles embedded in thin silicon dioxide film by optical reflection property Fulltext Access 6 Pages 2005
Target orientation dependence of the charge fractions observed for low-energy multicharged ions (Neq+ and Fq+) backscattered from RbI(100) Fulltext Access 6 Pages 2005
Influence of helium-dielectric barrier discharge treatments on the adhesion properties of polyamide-6 surfaces Fulltext Access 6 Pages 2005
Dependence of morphology of pulsed-laser deposited coatings on temperature: a kinetic Monte Carlo simulation Fulltext Access 6 Pages 2005
Effect of pyridine and picolines on the electrocrystallisation of nickel from sulphate solutions Fulltext Access 6 Pages 2005
Effects of MgO thin film thickness and deposition rate on the lifetime of ac plasma display panel Fulltext Access 6 Pages 2005
Optimum conditions for ozone formation in a micro dielectric barrier discharge Fulltext Access 6 Pages 2005
The effects of plasma surface modification on the molding adhesion properties of Film-BGA package Fulltext Access 6 Pages 2005
Hot corrosion of some superalloys and role of high-velocity oxy-fuel spray coatings-a review Fulltext Access 6 Pages 2005
Improvement of high-speed turning performance of Ti-Al-N coatings by using a pretreatment of high-energy ion implantation Fulltext Access 6 Pages 2005
Growth of highly orientated 0.65Pb(Mg1/3Nb2/3)O3-0.35PbTiO3 films by pulsed laser deposition Fulltext Access 6 Pages 2005
Stress and surface morphology of TiNiCu thin films: effect of annealing temperature Fulltext Access 6 Pages 2005
Effect of Pt film thickness on PtSi formation and film surface morphology Fulltext Access 6 Pages 2005
Microstructural characterization of biomedical titanium oxide film fabricated by electrochemical method Fulltext Access 6 Pages 2005
A novel thin film urea biosensor based on copolymer poly(N-3-aminopropylpyrrole-co-pyrrole) film Fulltext Access 6 Pages 2005
Microstructure and tribological properties of magnetron sputtered nc-TiC/a-C nanocomposite Fulltext Access 6 Pages 2005
Preparation and electrochemical characterization of a new nanosensor based on self-assembled monolayer of cysteamine functionalized with phosphate groups Fulltext Access 6 Pages 2005
Improvement of SiO2 pattern profiles etched in CF4 and SF6 plasmas by using a Faraday cage and neutral beams Fulltext Access 6 Pages 2005
A possible thermodynamic mechanism of craters formation on metal surfaces caused by intense pulsed ion beams Fulltext Access 6 Pages 2005
Properties of NdFeB film grown on silicon substrate by PLD under external magnetic field Fulltext Access 6 Pages 2005
The role of surface oxidation in friction processes on molybdenum nitride thin films Fulltext Access 6 Pages 2005
TEM study on chromium nitride coatings deposited by reactive sputter method Fulltext Access 6 Pages 2005
Microstructure and wear characteristics of cobalt-based alloy deposited by plasma transferred arc weld surfacing Fulltext Access 6 Pages 2005
Laser cladding of Al2O3 coating on aluminium alloy by thermite reactions Fulltext Access 6 Pages 2005
Effects of residual stress on the mechanical and structural properties of TiC thin films grown by RF sputtering Fulltext Access 6 Pages 2005
Tribological and dry machining evaluation of superhard TiB2/TiC multilayer coatings deposited on Si(001), M2 steel, and C3 WC cutting tool inserts using magnetron sputtering Fulltext Access 6 Pages 2005
Effect of processing on the structure and wear properties of sputtered zirconium oxide thin films Fulltext Access 6 Pages 2005
Study of mechanical properties and stress of tetrahedral amorphous carbon films prepared by pulse biasing Fulltext Access 6 Pages 2005
Bioactive calcium phosphate coating prepared on H2O2-treated titanium substrate by electrodeposition Fulltext Access 6 Pages 2005
Electroless nickel-phosphorus plating on Ni-Zr-Ti-Si-Sn amorphous powder Fulltext Access 6 Pages 2005
Surface characterization of thin film induced by He+ ion-beam irradiation into PLLA Fulltext Access 6 Pages 2005
Effects of ion beam on nanoindentation characteristics of glassy polymeric carbon surface Fulltext Access 6 Pages 2005