کد مقاله | کد نشریه | سال انتشار | مقاله انگلیسی | نسخه تمام متن |
---|---|---|---|---|
1055553 | 1485244 | 2016 | 7 صفحه PDF | دانلود رایگان |
• Sugarcane bagasse was used to prepare a solid amine adsorbent for CO2 capture.
• The adsorbent is low cost and has a remarkable CO2 adsorption amount (5.01 mmol/g).
• Moisture could significantly increase CO2 adsorption capacity of the adsorbent.
A low-cost solid amine adsorbent for CO2 capture was prepared by using sugarcane bagasse (SB), a dominant agro-industrial residue in the sugar and alcohol industry as raw materials. In this preparation process, acrylamide was grafted on SB, and the grafted fiber was then aminated with different type of amine reagents to introduce primary and secondary amine groups onto the surface of SB fibers. The graft and amination conditions were optimized. The prepared solid amine adsorbent showed remarkable CO2 adsorption capacity and the adsorption capacity of the solid amine adsorbent could reach 5.01 mmol CO2/g at room temperature. The comparison of adsorption capacities of amine fibers aminated with various amination agents demonstrated that fibers aminated with triethylenetetramine would obtain higher adsorption capacities and higher amine efficiency. These adsorbents also showed good regeneration performance, the regenerated adsorbent could maintain almost the same adsorption capacity for CO2 after 10 recycles.
Figure optionsDownload as PowerPoint slide
Journal: Journal of Environmental Management - Volume 168, 1 March 2016, Pages 142–148