Influence of lightweight aggregate on the microstructure and durability of mortar

The results of an investigation on the effect of dry and prewetted lightweight aggregates on the microstructure and durability of mortar are presented in this paper. The results are compared with those obtained for normal aggregate mortar. There appears to be only a small difference in the microstructure of the interfacial transition zone (ITZ) between dry and prewetted lightweight aggregate mortars. The porous ITZ surrounding lightweight aggregate appears to extend for about 10 and 15 μm from the aggregate surface for dry and prewetted lightweight aggregates, respectively. The ITZ for dry and prewetted lightweight aggregates seems to be surrounded by dense paste that extends from 10 to about 50 μm from the aggregate surface. This dense paste has lower porosity than that observed in the bulk paste located 50 μm and farther from aggregate surface. The normal aggregate mortar prepared with the same water/cement ratio appears to have porous ITZ that extends beyond 35 μm from the aggregate surface. The dry and prewetted lightweight aggregate mortars seem to have a lower sorptivity and electrical conductivity than does the normal aggregate mortar. Lightweight aggregate mortars also appear to have excellent resistance to sulfate attack as compared with normal aggregate mortar.