Characterization of electrodes modified by one pot or step by step electro-click reaction and axial ligation of iron tetracarboxyphthalocyanine

The modification of the glassy carbon electrode (GCE) was carried out using two methods. The first method is simultaneous electropolymerization and electro-click followed by immersion into a solution of dimethyl formamide (DMF) containing FeTCPc. The second method is step by step whereby electropolymerization is carried out first followed by electro-click and then immersion into a DMF solution containing FeTCPc. From the electrochemical characterization, it was observed that the second route (step by step method) was the best as indicated by the ferricyanide studies (cyclic voltammetry and scanning electrochemical microscopy). In the electrooxidation of hydrazine, we obtained a potential of 0.26 V. Of interest were the detection limit of 6.4 μM and the catalytic rate constant of 2.1 × 109 cm3 mol−1 s−1. This shows that the sensor can be used for the electrooxidation of hydrazine.

Figure optionsDownload as PowerPoint slide