Test methodDirect fracture toughness determination of a ductile epoxy polymer from digital image correlation measurements on a single edge notched bending sample

This work presents a combined experimental and numerical study on the fracture toughness behaviour of a ductile epoxy resin system. Quasi-static fracture tests using single edge notched bending (SENB) specimens were conducted under room temperature conditions. In addition, the digital image correlation technique was employed to experimentally map the full-field displacements and strains around the notch and crack tip, allowing direct calculation of the J-integral fracture toughness. The magnitude of fracture toughness was found to be 1.52 ± 0.03 kJ/m2, showing good consistency with the results measured according to the standard analytical formulations. A numerical model of the single edge notch bending specimen was built to compute the local strain field around the crack tip, together with the fracture toughness parameter. Good agreement was confirmed for both the experimental J-integral fracture toughness and the local surface strains around the crack-tip from the digital image correlation based optical technique, compared to the results obtained by numerical simulation. The fracture surfaces of the samples were examined using an optical microscope to analyze the failed surface morphology and the corresponding failure mechanisms.