Surface dilatational behavior of β-casein at the solution/air interface at different pH values

The surface tension and dilatational visco-elasticity isotherms for β-casein determined at pH 7 and 9 are essentially the same, but differ remarkably from those measured at the isoelectric point (i.e.p.) of the protein at pH 5. A recently developed thermodynamic model is applied to the experimental data, which were not only obtained at equilibrium, but also under quasi-equilibrium conditions. It turned out that such a model can be adequately applied to data obtained not too far from the equilibrium state of a protein adsorption layer. The change in the model parameters allows to understand slow changes in the structure of the adsorption layer. Even at pH 5, where β-casein is most hydrophobic and in its most compact conformation, the data point to the fact that conformational changes may happen at the interface upon adsorption.

Figure optionsDownload as PowerPoint slideHighlights
► Surface tension and dilatational visco-elasticity isotherms are determined for BCS at pH 5, 7 and 9.
► A thermodynamic model is applied to the experimental data for the interpretation.
► The model parameters allow understanding slow changes in the adsorption layer structure.
► Even at pH 5, where BCS partial unfolding at the interface is observed.