The interaction of two indenters in analogue experiments and implications for curved fold-and-thrust belts

Scaled analogue experiments are used to investigate the indentation of two basement blocks into a sedimentary basin and the formation of a fold-and-thrust belt. The experimental set-up has two adjacent indenters moving in parallel with a velocity difference. The slow indenter moves with a relative velocity ranging from 40 to 80% of that of the fast one.In a first experimental series, quartz sand and low-friction glass beads represent the sediment stack and its basal detachment, respectively; silicone oil simulates a viscous detachment in the second series of experiments. The surface evolution and the spatio-temporal strain distribution are derived from particle image velocimetry (PIV). Together with the 3D finite structure derived by cutting the models at the end of each experiment, this allows the analysis of the structural evolution of the experimental wedges.Thrusting wedge development depends crucially on the relative velocity: when the slow indenter moves with a velocity of more than 55% of the fast indenter, a single curved thrust wedge develops. The wedge becomes decoupled along strike-slip zone at large velocity differences, i.e. when the slow indenter moves slower than 55% of the faster indenter. Consequently the thrust front is strongly curved at high (55-60%) and smoothly curved at low velocity differences (70-80%); in all cases curvature increases during indentation. Along the most strongly curved portion of the thrust wedge, the transfer zone rises, particle rotation and material transport oblique to the indentation direction occur directed toward the front of the slow indenter. Thrusting cycles are timed by the fast indenter and influence thrusting in front of the slow indenter. Thrusts nucleate in front of the fast indenter wedge and propagate laterally to the slow indenter front. This implies distant effects of wedge growth active hundreds of kilometres along-strike of orogens.Silicone oil as a detachment induces a low-angle wedge, which is less curved than in the glass beads experiments, and shows variable thrust vergence with fore- and back-thrusts. We compare our experimental results with the curved fold-and-thrust belts of the Tajik basin in front of the Hindu-Kush and Pamir indenters; our results are able to explain several first-order features.

Research Highlights► Two indenter models with different velocities generate curved fold-and-thrust belts. ► Long-lasting deformation of continuous salient occurs when velocities are similar. ► Decoupling of the wedge occurs when the velocity difference is big/huge. ► Model applies to the Tajik basin and the Sulaiman Range. ► Lateral fault propagation along strike is caused by differences in velocity.