Convective boiling in a parallel microchannel heat sink with a diverging cross section and artificial nucleation sites

To develop a highly stable microchannel heat sink for boiling heat transfer, three types of diverging microchannels (Type 1, Type 2 and Type 3) were designed to experimentally investigate the effect of different distributions of artificial nucleation sites (ANS) on the enhancement of flow boiling heat transfer, in 10 parallel diverging microchannels with a mean hydraulic diameter of 120 μm. Water was used as the working fluid with mass flux, based on the mean cross section area, ranging from 99 to 297 kg/m2 s. The Type-1 system did not contain any ANS; the Type-2 system contained ANS distributed uniformly along the downstream half of the channel; and the Type-3 system contained ANS distributed uniformly along the entire channel. The ANS are laser-etched pits on the bottom wall of the channel and have a mouth diameter of approximately 20–22 μm, as indicted by the heterogeneous nucleation theory. The results of the present study reveal that the presence of ANS for flow boiling in parallel diverging microchannels significantly reduces the wall superheat and enhances the boiling heat transfer performance. The Type-3 system shows the best boiling heat transfer performance.