Estimation of the measurement uncertainty in the anisotropy test

The evaluation of the sheet metal drawability in mechanical shaping processes depends on a large number of analysis, among which the anisotropy evaluation. Nowadays, there is no Brazilian test laboratory accredited by the Metrology, Quality and Technology National Institute (INMETRO) to perform this analysis. So, the object of the present work is to establish a procedure for the estimation of the measurement uncertainty in the plastic anisotropy ratio of sheet metals, in accordance to the Guide to the Expression of Uncertainty in Measurement (GUM), aiming at the accreditation of this test in the Physical Metallurgy Laboratory. As results, we present the calculations performed and the uncertainty form proposed, and an analysis of which sources contributed the most for the uncertainty in the execution of a test. Finally, we propose improvement actions aiming at the reduction of the calculated uncertainty and the adequacy of the Measurement System for the desired application.