Effect of process parameters on the macrostructure and defect formation in friction stir lap welding of AA5456 aluminum alloy

Friction stir welding could be considered as a suitable technique for joining of aluminum alloys due to the emerging of different problems in fusion welding of these alloys, especially in lap joint designs. For this purpose, it is necessary to optimize the process parameters while in this study, the combined effects of tool rotation and welding travel speed on the macrostructure and defect formation of friction stir lap welding of AA5456 was investigated. The rotating tool was plunged from the 5 mm-thick AA5456-H321 (top sheet) surface into the 2.5 mm-thick AA5456-O (bottom sheet) and lap joints were fabricated by rotational speeds of 300, 600, 800 and 1000 rpm and welding speeds of 15, 30, 60 and 100 mm min−1. The effect of tool rotation and welding speed on the macrostructure, material flow and defect formation, i.e. hooking, kissing-bond and cavity, were studied by optical microscopy and scanning electron microscope. The results declared that hooking height decreased as the welding speed increased while kissing-bond was formed at higher welding speeds. Moreover, hooking region was extended as the tool rotational speed increased. However, at a high rotational speed, cavity was even created.

Figure optionsDownload as PowerPoint slide