Octadecyl grafted MCM-41 silica spheres using trifunctionalsilane precursors – preparation and characterization

MCM-41 silica spheres were prepared via the pseudomorphic route. Subsequent surface modification of the mesoporous silica spheres was achieved by two silylating agents, n-octadecyltrihydridosilane and n-octadecyltrimethoxysilane, which provided different surface coverages. The MCM-41 pore structure, surface properties and morphological features were examined by small angle X-ray scattering, nitrogen adsorption–desorption and scanning electron microscopy. The investigations revealed an influence of the silica source on the mesoporous structure, as reflected by a higher long-range order for the pores in MCM-41 spheres prepared from Kromasil silica. Surface modification is accompanied by a reduction of the surface area, pore diameter and pore volume of the MCM-41 materials, whereas the spherical morphology of the spheres is retained. The degree of grafting and cross-linking of the alkylsilanes was determined by 29Si NMR spectroscopy. A higher degree of alkyl chain grafting was observed for the solvent extracted MCM-41 spheres and for samples prepared via surface polymerization.FTIR and 13C NMR spectroscopies were employed to study the conformational behaviour and mobility of the grafted octadecyl chains. The conformational order was found to strongly depend on the history of the MCM-41 supports (calcination, solvent extraction) and on the actual surface modification procedure. In general, a lower conformational order was observed for the present mesoporous alkyl modified silica spheres as compared to conventional C18 modified silica gels which is mainly attributed to the lower surface coverage.