Analysis and control of the near-wake flow over a square-back geometry

A 3D numerical simulation, based on the Lattice Boltzmann method is carried out on the near-wake flow behind a generic square-back blunt body to analyze and establish a method to control the near-wake flow. The flow topology is described by the velocity and the pressure fields. The influence of the wake vortices on the aerodynamic drag is clarified and quantified. In order to reduce this drag, an active open-loop flow control is applied by continuous blowing devices distributed around the base periphery. The blowing effect on the behind body flow is a reduction of the wake section and of the total pressure loss in the wake and an increase of the static pressure on the base of the square body. This control leads to a significant drag reduction of ΔCx = −29% with a blowing velocity of 1.5V0. The efficiency is then studied, and we found that the most efficient control is obtained for a blowing velocity of 0.5V0 and a jet angle of 45°. In this case, a 20% drag reduction is obtained, and the energy needed to control the system is seven times lower than the energy saved by the control.