Effect of the temperature on the strength of adhesively bonded single lap and T joints for the automotive industry

Adhesively bonded lap and T joints are used extensively in the manufacture of automotive structures. In order to determine the effect of using a structural adhesive instead of spot-welding, a detailed series of tests, supported by finite element analyses, was conducted using a range of loadings. The adhesive was a toughened epoxy and the adherend was a grade of mild steel typical of that used in the manufacture of car bodyshells. The lap joints were tested in tension (which creates shear across the bondline) and three point bending. Previous studies at room temperature have shown that joint failure is dictated by adherend yielding and adhesive strain to failure. In the present study, to asses the effect of temperature that an automotive joint might experience in service, tests were carried out at −40 and +90 °C. It is shown that the failure criterion proposed at room temperature is still valid at low and high temperatures, the failure envelope moving up and down as the temperature increases or decreases, respectively.