Single setup estimation of a five-axis machine tool eight link errors by programmed end point constraint and on the fly measurement with Capball sensor

Five-axis machine tools can be programmed to keep a constant nominal tool end point position while exercising all five axes simultaneously. This kinematic capability allows the use of a 3D proximity sensing head mounted at the spindle to track the position changes of a precision steel ball mounted on the machine table effectively measuring the 3D Cartesian volumetric errors of the machine. The new sensing head uses capacitive sensors to gather data on the fly during a synchronized five-axis motion which lasts less than 2 min. Because the measured volumetric errors are strongly affected by the link geometric errors, they can be used to estimate the link errors through an iterative procedure based on an identification Jacobian matrix. The paper presents the new sensor, the identification model and the experimental validation. The approach allows all eight link errors i.e. the three squarenesses of linear axes and the four orientations and center lines offset of the rotary axes to be estimated with the proposed single setup test. The estimation approach is performed on a horizontal five-axis machine tool. Then, using the estimated link errors, the volumetric errors are predicted for axes combinations different from those used for the identification process. The estimated machine model correctly predicts 52–84% of the volumetric errors for the tested trajectories.