On-line identification of operational loads using exogenous inputs

In this paper, a method is proposed that enables the on-line determination of operational forces. As input the method uses dynamical response measurements and the measurement of a known force (due to an exogenous excitation input) at one particular location (where it is possible to put an excitation device and a force sensor). A periodic signal is taken as the exogenous excitation. It is assumed that apart from the known force there is also an unknown force (at an unknown location) that is acting on the structure. As a first step in the procedure, the measured responses and the known (i.e. measured) force are compensated in order to eliminate the contribution due to the unknown force. From these compensated measurements the complete FRF matrix is calculated. Then, the forces are calculated from the original (uncompensated) responses and the inverted complete FRF matrix. The method is validated both on a simulation and measurements of a steel beam with an applied unknown impact excitation.