Optimized FIB silicon samples suitable for lattice parameters measurements by convergent beam electron diffraction

The aim of this paper is to check the effect of artefacts introduced by focused ion beam (FIB) milling on the strain measurement by convergent beam electron diffraction (CBED). We show that on optimized silicon FIB samples, the strain measurement can be performed with a sensitivity of about 2.5 × 10−4 which is very close to the theoretical one and we conclude that FIB preparation can be suitable for such measurements in microelectronic devices.To achieve this, we first used CBED and electron energy loss spectroscopy (EELS) which provide a procedure permitting an exact knowledge of the sample geometry, i.e. the thickness of both amorphous and crystalline layers. This procedure was used in order to measure the FIB-amorphized sidewall layer. It was found that if the FIB preparation is optimized one can reduce this amorphous layer down to around 7 nm on each side. Secondly different preparation techniques (cleavage, Tripod™ and FIB) permit to check if the surface damaged layer introduced by FIB influences the strain state of the sample. Finally, it was found that the damaged layer does not introduce measurable strain in pure silicon but reduces appreciably the quality of the CBED patterns.