Coarsening of γ (Ni-Al solid solution) precipitates in a γⲠ(Ni3Al) matrix; a striking contrast in behavior from normal γ/γⲠalloys Fulltext Access 6 Pages 2005
Comparison of recrystallization texture in cold-rolled continuous cast AA5083 and 5182 aluminum alloys Fulltext Access 6 Pages 2005
Strain induced γⲠprecipitation in nickel base superalloy Udimet 720 using a stress relaxation based technique Fulltext Access 6 Pages 2005
Long term creep of TiAl + W + Si with polycrystalline and columnar grain structures Fulltext Access 6 Pages 2005
Improvement in H-sorption kinetics of MgH2 powders by using Fe nanoparticles generated by reactive FeF3 addition Fulltext Access 6 Pages 2005
Classification of microstructural evolution during large strain high Z deformation of a 0.15 carbon steel Fulltext Access 6 Pages 2005
Phase formation during the devitrification of Al-rich melt-spun Al-8.5Ni-5.0Y-3.0(Co,Fe) alloys Fulltext Access 6 Pages 2005
Grain size effect on multiple-stage transformations of a cold-rolled and annealed equiatomic TiNi alloy Fulltext Access 6 Pages 2005
Influence of nickel boride additions on sintering behaviors of injection moulded 17-4 PH stainless steel powder Fulltext Access 6 Pages 2005
Effect of the pore size of TiO2-loaded activated carbon fiber on its photocatalytic activity Fulltext Access 6 Pages 2005
A quantitative study of the hardness of a superhard nanocrystalline titanium nitride/silicon nitride coating Fulltext Access 6 Pages 2005
Elevated temperature wear behaviors of a Co-Mo-Si ternary metal silicide alloy Fulltext Access 6 Pages 2005
Lean manufacturing beefs up marginspull systems, takt time, and one-piece flow benefit the operation of a powder coating system Fulltext Access 6 Pages 2005
The mechanism of the anelastic X relaxation in the intermetallic compound Fe3Al Fulltext Access 6 Pages 2005
Effect of microstructural stability on creep behavior of 47XD TiAl alloys with fine-grained fully lamellar structure Fulltext Access 6 Pages 2005
Room-temperature tensile property and fracture behavior of recrystallized B2-type CoZr intermetallic compound Fulltext Access 6 Pages 2005
Synthesis and microstructural characterization of Ti-Al3Ti metal-intermetallic laminate (MIL) composites Fulltext Access 6 Pages 2005
Low cycle fatigue behavior of Zn-22mass%Al alloy exhibiting high-strain-rate superplasticity at room temperature Fulltext Access 6 Pages 2005
Liquidus and solidus boundaries in the vicinity of order-disorder transitions in the Fe-Si system Fulltext Access 6 Pages 2005
Hydrogen degradation of a boron-bearing steel with 1050 and 1300Â MPa strength levels Fulltext Access 6 Pages 2005
Crystal structure and electrochemical characteristics of La0.9Mg0.1Ni5âxSnx (x = 0.1, 0.2, 0.3, 0.4) alloy electrodes Fulltext Access 6 Pages 2005
A novel fiber Bragg grating acoustic emission sensor head for mechanical tests Fulltext Access 6 Pages 2005
On the electron structure of Mn-, Ni- and Cr-Ni-Mn austenite with different stacking fault energy Fulltext Access 6 Pages 2005
Formation of coarse-grained inter-particle regions during hot isostatic pressing of nanocrystalline powder Fulltext Access 6 Pages 2005
Analysis of strain uniformity during multi-pressing in equal channel angular extrusion Fulltext Access 6 Pages 2005
The effect of carbon and reactive element dopants on oxidation lifetime of FeAl Fulltext Access 6 Pages 2005
Critical assessment of computational thermodynamics in the alloy design of PM high speed steels Fulltext Access 6 Pages 2005
Dynamic recrystallization of ferrite during warm deformation of ultrafine grained ultra-low carbon steel Fulltext Access 6 Pages 2005
On the apparent saturation of the average disorientation angle with plastic deformation Fulltext Access 6 Pages 2005
Ab initio calculation of the bcc Mo-Al (molybdenum-aluminium) phase diagram: Implications for the nature of the ζ2-MoAl phase Fulltext Access 6 Pages 2005
Martensitic surface relief in an Fe-Mn-Si-based alloy strained by bending Fulltext Access 6 Pages 2005
Crosshead speed dependence of the notch tensile strength of a high strength steel in the presence of hydrogen Fulltext Access 6 Pages 2005
Backward extrusion of Al-Al3Ti functionally graded material: Volume fraction gradient and anisotropic orientation of Al3Ti platelets Fulltext Access 6 Pages 2005
An analysis of kinetic Monte Carlo simulation as a tool for modelling strain ageing Fulltext Access 6 Pages 2005
Effects of the doping element on crystal structure and magnetic properties of Sm(Co,M)7 compounds (M=Si, Cu, Ti, Zr, and Hf) Fulltext Access 7 Pages 2005
Oxidation behavior of gamma alloys designed for high temperature applications Fulltext Access 7 Pages 2005
Evolution of oxide scales on an ODS FeAl intermetallic alloy during high temperature exposure in air Fulltext Access 7 Pages 2005
Intermediate products of hydriding combustion synthesis of Mg2NiH4 studied by optical microscopy and field-emission scanning electron microscopy Fulltext Access 7 Pages 2005
Structural and magnetic characterization of DyFexSn2 (0â¤xâ¤0.3) intermetallics Fulltext Access 7 Pages 2005
Superplastic deformation behavior of Zr41.25Ti13.75Ni10Cu12.5Be22.5 bulk metallic glass in the supercooled liquid region Fulltext Access 7 Pages 2005
Influence of the microstructure on the formation of alumina scales on near stoichiometric RuAl produced by arc melting Fulltext Access 7 Pages 2005
Quasicrystalline phase formation in the mechanically alloyed Al-Cu-Fe system Fulltext Access 7 Pages 2005
Experimental and theoretical study of redistribution of alloying elements in Ni-based weld joints at high temperatures Fulltext Access 7 Pages 2005
Mechanical properties of Fe-Al-M-C (M=Ti, V, Nb, Ta) alloys with strengthening carbides and Laves phase Fulltext Access 7 Pages 2005
Strength improvement and fracture mechanism in Fe40Al/TiC composites with high content of TiC Fulltext Access 7 Pages 2005
Crystal structure, 57Fe Mössbauer spectroscopy and magnetization of UxFe6Sn6 (0â¤xâ¤0.6) Fulltext Access 7 Pages 2005
Comparative study of deuterium desorption from Pd-coated Zr-based amorphous and quasicrystalline alloys Fulltext Access 7 Pages 2005
Mapping the compaction and sintering response of tungsten-based materials into the nanoscale size range Fulltext Access 7 Pages 2005
The temperature ranges for maximum effectiveness of grain growth inhibitors in WC-Co alloys Fulltext Access 7 Pages 2005
Miscibility gap of B2 phase in NiAl to Cu3Al section of the Cu-Al-Ni system Fulltext Access 7 Pages 2005
Superplasticity of Ni-rich single phase NiAl intermetallics with large grains Fulltext Access 7 Pages 2005
Mechanical properties of single crystal YCu and (Tb0.88Dy0.12)Zn B2 intermetallic compounds Fulltext Access 7 Pages 2005
Properties of passive film formed on CP titanium, Ti-6Al-4V and Ti-13.4Al-29Nb alloys in simulated human body conditions Fulltext Access 7 Pages 2005
Tensile fracture characteristics and deformation behavior of a Zr-based bulk metallic glass at high temperatures Fulltext Access 7 Pages 2005