Warm die compaction and sintering of titanium and titanium alloy powders

A study has been made of the effect of non-lubricated warm die (200 °C) compaction on the densification of hydride-dehydride (HDH) Ti powder, pre-alloyed (PA) Ti-6Al-4V and Ti-10V-2Fe-3Al powders, and HDH Ti and V-Fe-Al master alloy powder blends, compared to cold die compaction. Depending on the compaction pressure, which was varied from 200 to 1000 MPa, non-lubricated warm die (200 °C) compaction was very effective for −100 mesh HDH Ti powder, increasing the green density by 5.0-9.4% theoretical density (TD). Die wall lubrication with stearic acid showed no influence on the green density when compacted at 800 MPa. With warm die (200 °C) compaction, achieving a green density of greater than 90%TD was straightforward for HDH Ti powder when compacted at ≥750 MPa. Accordingly, near pore-free (≥99.5%TD) Ti microstructures were obtained after sintering at 1300 °C for 120 min in vacuum when compacted at 1000 MPa. The resulting increment in the sintered density was between 2.0%TD and 4.4%TD. Warm die (200 °C) compaction showed no effect on PA Ti-10V-2Fe-3Al powder and only a small effect on PA Ti-6Al-4V powder when compacted at 1000 MPa. However, it was still virtually effective for Ti-10V-2Fe-3Al powder blends made of HDH Ti powder and V-Fe-Al master alloy powder. The observations were compared with literature data and discussed in accordance with the yield strength of Ti, Ti-6Al-4V, Ti-10V-2Fe-3Al and Al3V as a function of temperature.