Creating movable interfaces by micro-powder injection moulding

This paper presents a novel in situ technique to produce articulated components with high-precision, micro-scale movable interfaces by micro-powder injection moulding (μPIM). The presented process route is based on the use of micro-scale sacrificial layer between the movable subcomponents which is eliminated during the debinding step, creating a dimensionally-controlled, micro-scale mobile interface. The fabrication technique combines the advantages of micro-powder overmoulding, catalytic debinding and sintering. The demonstrated example was a finger bone prosthesis joint consisting of two sub-components with an interface between components of 200 μm in size. The geometries of the sub-components were designed such that they are inseparable throughout the process whilst allowing them to move relative to each other after the debinding stage. The components produced showed the feasibility of the process route to produce readily-assembled meso-, and potentially micro-, scale articulated systems.