Simulation of dispersion and collection process of agglomerated particles in collision with fibers using discrete element method

The behavior of agglomerates in collision with fibers was simulated using the three-dimensional modified discrete element method and the influences of several factors on the fraction of collected particles were examined. Furthermore the single fiber collection efficiency for agglomerated particles was also investigated. In the case where gas velocity is quite low, agglomerates are only deformed but barely dispersed and thus collected as a single deformable particle. By contrast above some critical gas velocity, constituent particles are dispersed and at the same time partly collected on fibers. The fraction of collected particles first increases then decreases as the van der Waals attractive force between particle and fiber increases. The reason for the decrease in fraction of collected particles in strong adhesion region is that the smooth deformation of agglomerates along the fiber surface is inhibited by too strong adhesion. It was also suggested that there exists an optimum size ratio between the agglomerate size and fiber radius for the collection fraction. This is also closely related to the deformation of agglomerate along the fiber surface. In case of non-agglomerated particle collision, all the particles entering within the collision region are collected by fiber. By contrast in case of agglomerate collision, the dispersion of agglomerates as well as collection occurs in the same process and all the particles colliding with the fiber are not necessarily collected. Consequently the single fiber collection efficiency considerably decreases comparing to that for non-agglomerated particle collision.