کد مقاله کد نشریه سال انتشار مقاله انگلیسی نسخه تمام متن
1508749 1511146 2016 9 صفحه PDF دانلود رایگان
عنوان انگلیسی مقاله ISI
The Effect of Processing Parameter on Mechanical Properties of Short Glass Fiber Reinforced Polyoxymethylene Composite by Direct Fiber Feeding Injection Molding Process
ترجمه فارسی عنوان
اثر پارامتر پردازش بر خواص مکانیکی کامپوزیت پلی اتیلن تقویت شده فیبر شیشه ای کوتاه با فرایند ریخته گری تزریقی مستقیم فیبر
کلمات کلیدی
پلی اکسیدیلن، فیبر شیشه ای کوتاه تغذیه مستقیم فیبر، قالب گیری تزریقی، کلی تیسون
موضوعات مرتبط
مهندسی و علوم پایه مهندسی انرژی انرژی (عمومی)
چکیده انگلیسی

This research describes the effect of processing parameters as matrix feeding speed, screw rotational speed and cylinder temperature of direct fiber feeding injection-molded process on properties of short glass fiber reinforced polyoxymethylene composite. The increasing of matrix feeding speed at screw rotational speed of 172 rpm led to the reduction of fiber loading content and increasing of fiber length. Whereas the higher screw rotational speed impacted on the increasing of fiber loading content and fiber length. However, its tensile properties were lower than the molded at screw rotational speed 172 rpm. When fiber loading content over 20 wt.%, tensile strength of both conditions reached the same values because the poor fiber distribution especially at screw rotational speed of 258 rpm. Then Kelly – Tyson's equation was used to predict their tensile strength. It was found that tensile strength at maximum fiber loading content at screw rotational speed of 172 rpm and 258 rpm are lower than the calculated strength values around 28.9% and 31.8%, respectively. The effect of cylinder temperature was also elucidated.

ناشر
Database: Elsevier - ScienceDirect (ساینس دایرکت)
Journal: Energy Procedia - Volume 89, June 2016, Pages 255–263
نویسندگان
, , , ,