Conceptual design and analysis of a passive residual heat removal system for a 10 MW molten salt reactor experiment

• Conceptual design of a passive residual heat removal system is proposed for 10 MW molten salt reactor experiment.
• The principle, main components and design parameters of the system are presented.
• Thermal-hydraulic behaviors of the system are numerically analyzed in the code of C++.
• Three operational schemes are proposed for the passive residual heat removal system.

A conceptual design of a passive residual heat removal system was developed for a 10 MW molten salt reactor experiment (MSRE) designed by Oak Ridge National Laboratory (ORNL). The principle, main components and design parameters of the system were presented, and thermal-hydraulic behaviors, such as natural circulation and heat removal ability, were numerically analyzed in the code of C++, especially for the bayonet cooling thimbles. The results show that the system can effectively remove decay heat in the molten salt in an MSRE and has a heat removal rate that approximates to the decay heat generation rate, thus causing the temperature of the molten salt to decrease steadily. The width of the gas gap in the bayonet cooling thimbles has little effect on either the heat exchange or the natural circulation inside the thimbles, while the width of the steam riser, in spite of its slight effect on the heat transfer of the system, greatly influences the natural circulation. With the width of the steam riser increase from 3.6 to 5.1 mm, the mass flow rate increases from 1.9 kg/s to 4.79 kg/s. Finally, three operational schemes were proposed for the passive residual heat removal system, among which that of reducing the bayonet cooling thimbles by three-quarters had the best comprehensive performance.