Preparation of nanostructure mixed copper-zinc oxide via co-precipitation rout for dye-sensitized solar cells: The influence of blocking layer and Co(II)/Co(III) complex redox shuttle

Mixed copper-zinc oxide nanostructures (average size 43 nm) were effectively fabricated via co-precipitation route. Field-emission scanning electron microscope (FESEM), powder X-ray diffraction (XRD), fourier-transform infrared spectroscopy (FT-IR) and UV–vis diffuse reflectance spectrum (DRS) were used to characterize the properties of the oxides. At the optimized condition, copper-zinc oxide nanostructures were used for fabrication of working electrodes by doctor blade technique on the fluorine-doped tin oxide (FTO) in dye sensitized solar cells. Their photovoltaic behavior were compared with standard using D35 dye and an electrolyte containing [Co(bpy)3](PF6)2, [Co(pby)3](PF6)3, LiClO4, and 4-tert-butylpyridine (TBP). The ranges of short-circuit current (Jsc) from 0.13 to 0.30 (mA/cm2), open-circuit voltage (Voc) from 0.20 to 0.51 V, and fill factor from 0.34 to 0.29 were obtained for the DSSCs made using the working electrodes. A titania blocking layer on the copper-zinc oxide surface improve both the open-circuit voltage (Voc), short-circuit current (Jsc) and the power-conversion efficiency is consequently enhanced by a factor of approximately five.

Figure optionsDownload as PowerPoint slide